Abstract:Journal of Composite Materials, Ahead of Print. The multi-directional laminate CCF800H/AC631 bismaleimide composite material was exposed for a long time under the thermal-cycling environment (−60°C ∼+180°C), and the mass loss rate, FTIR spectra, DMA, tensile strength were tested. The fatigue stress level was determined according to the tensile strength and the fatigue performance of the before and after the thermal-cycling environment was tested. Macroscopic visual inspection and ultrasonic C-scan were used to characterize and analyze the fatigue damage of composite materials. The results show that with the increase in the number of thermal cycles, the mass loss of the composite material started with increased rapidly and then basically flat. The C/BMI composites underwent obvious thermal oxygen aging. After thermal-cycling, it would lead to changes in dynamic mechanical properties by a certain degree of post-curing, physical aging, and local interface debonding in composite materials. With the thermal cycles increased the composite material tensile strength first increased slightly and then decreased rapidly. After 300 thermal cycles, the composite materials occurred slightly damaged, and the fatigue life was apparently reduced compared with the original state. The fatigue failure modes of composite materials are mainly fiber fracture and multi-directional laminate delamination. At high stress levels, the stiffness of the specimen after thermal-cycling are lower decrease compared with original specimens, more stress levels would lead to more II stage rate of stiffness decline, and stiffness degradation curve and hysteretic energy recovery curve had enough effect to characterize damage effect of material environment induced by thermal-cycling environment factors.

Microstructure and Mechanical Properties of B/Al Composite after Thermal-Mechanical Cycling

Effect of thermal cycling on the mechanical properties of Cf/Al composites

Characterization on fatigue behavior and damage mechanism of C/BMI composites experienced thermal cycling

Microstructure Characterization of Al Matrix Composite Reinforced with Ti–6Al–4V Meshes after Compression by Scanning Electron Microscope and Transmission Electron Microscope

Microstructure characterization of Al matrix composite reinforced with Ti-6Al-4V meshes after compression by scanning electron microscope and transmission electron microscope.

Mechanical responses of in-situ TiB2/7050 composite subjected to monotonic and cyclic loadings: A comparative study with 7050-Al

Effect of Thermal Cycling Treatment on Microyield Behavior of Al 2 O 3 p/Al Composite

Microstructural evolution and thermal conductivity of diamond/Al composites during thermal cycling

Effect of (α + Β) Heat Treatment on Microstructure and Mechanical Properties of (tib + TiC)/Ti–B20 Matrix Composite

Effects of Thermal Cycling on Tensile Properties of Ti-6Al-4V Alloy at Room and Cryogenic Temperatures

Microstructure and Mechanical Properties of Al–B 4 C Composite at Elevated Temperature Strengthened with in Situ Al 2 O 3 Network

Microstructural evolution and mechanical properties of cast high-Li-content TiB 2 /Al-Li-Cu composite during heat treatment

Effect of Thermal Cycling on the Mechanical Properties of Carbon Nanotubes Reinforced Copper Matrix Nanolaminated Composites

Effect of Thermal Cycling Treatment on Microstructure and Mechanical Properties of AlNp/2024A1 Composite

Effects of Thermal Cycling on Mechanical Properties of Alnp/Al Composite

High fatigue performance and microscopic mechanisms of in-situ TiB 2 /7050Al composite at different temperatures

Effects of Nanosized Particles on Microstructure and Mechanical Properties of an Aged In-Situ TiB2/Al-Cu-Li Composite

Effects of thermal cycling on thermal expansion behaviors of β-LiAlSiO_4 reinforced copper matrix composites

Effect of thermal exposure on interface and tensile properties of aluminum borate whisker reinforced pure aluminum composite

Microstructure and Mechanical Properties of In-situ Synthesized(TiB+TiC)/Ti-8Al-1Mo-1V Composites

Variation of the Thermal Stress in the Al18b4o33w/Al Composite During Low Temperature Cycling