Abstract:This paper describes the molecular structure dependent thermoresponsive behaviors of pyrrolidone-based water-soluble polymers. A series of well-defined poly[N-(2-methacryloyloxyethyl)pyrrclidone] (PNMEP), poly[N-(3-acryloyloxypropyl)pyrrolidone] (PNAPP), and poly[N-(3-methacryloyloxypropyl)-pyrrolidone] (PNMEP) were synthesized via visible light activating RAFT polymerization at 25 degrees C. Kinetic studies indicate a rapid and well-controlled behavior of this polymerization. Gel permeation chromatography (GPC) and H-1 NMR analysis confirm their intact molecular structure, well-defined molecular weight, and narrow distribution. Laser light scattering and temperature-variable H-1 NMR analyses demonstrate that the cloud point of a PNMEP sample at a degree of polymerization (DP) of 96 is 1.5 degrees C lower than that of PNAPP at a DP = 104. Additional backbone methyl groups in PNMPP lead to a dramatic cloud point lowering, e.g. cloud point of PNMPP at a DP = 100 is 37 degrees C lower than that of PNAPP at a DP = 104. This is contrary to what was observed in poly(N-isopropylacrylamide) (PNIPA) and its polymethacrylamide analogues. These pyrrolidone-based polymers show a dramatic solvent isotopic effect that is different from that of PNIPA; e.g., the cloud point of PNMEP at a DP = 237 is 8.5 degrees C lower in D2O than in H2O. Increasing polymer chain length or hydrophobicity may suppress this solvent isotopic effect. This phase transition is correlated to Hofmeister series but more sensitive than PNIPA. Na2CO3 dramatically lowers cloud point, while NaI significantly improves cloud point, up to hill dissolution in H2O at 95 degrees C. The solvent isotopic effect in NaCl or Na2CO3 solution is the same as what observed in solution absent of salt. Upon heating D2O solution of PNMEP, the polymer first forms the hydrated irregular colloidal aggregates near the cloud point, the phase transition occurs at the fully hydrated state at cloud point, and further heating leads to the dehydration and separation from D2O. However, in NaCl solution, the dehydration or PNMEP occurs subsequently from apolar backbones, spacers, and finally pyrrolidone groups.

Influence of polymerization conditions on the viscosity and yield of poly(phenylene sulfide ether)

SYNTHESIS OF AROMATIC POLYESTERS FROM ESTERS OF DIPHENOLIC ACID AND ISOPHTHALOYL CHLORIDE BY INTERFACIAL POLYCONDENSATION

Experimental studies on PPTA synthesized by low-temperature polycondensation in mixed solvent N-methyl pyrrolidone and Calcium Chloride

Effect Of Polyethersulfone On The Mechanical And Rheological Properties Of Polyetherimide-Modified Epoxy Systems

Crystallization Behavior of Poly(styrene–ethylene) Copolymers Prepared by Sequential Polymerization

OXIDATIVE POLYMERIZATION BEHAVIOR OF 2,6-DIMETHYLPHENOL IN AQUEOUS MEDIA WITH POTASSIUM FERRICYANIDE

Synthesis of ethylene dichloride-based polysulfide polymers: investigation of polymerization yield and effect of sulfur content on solubility and flexibility

Synthesis and Characterization of Low‐molecular‐weight Poly(2,6‐dimethyl‐1,4‐phenylene Oxide) in Water

Ultrasonic Synthesis of Poly[2-Methoxy-5-(2 '-Ethylhexyloxy)-p-phenylenevinylene]

Influence of synthesis conditions on the electrical conductivity and relative molecular mass of PEDT

Synthesis and properties of copolymers of poly(ether ether sulfone)/semiaromatic polyamides (PEES/PA)

Effect of Molecular Structure on Thermoresponsive Behaviors of Pyrrolidone-Based Water-Soluble Polymers

Sodium sulfide-based polysulfide polymers: synthesis, cure, thermal and mechanical properties

Effect of Crystallization Temperature and Propylene Sequence Length on the Crystalline Structure of Propylene-Ethylene Random Copolymers

Study on the Melt Memory Effect and Melt Recrystallization Behavior of Crystallizable Biphenylene Poly(arylene ether sulfone ketone)

Synthesis and pyrolysis mechanism of phenolphthalein poly(aryl ether sulfone) containing isopropyl groups

Preparation and Characterization of Soluble Terpolymers from M‐phenylenediamine, O‐anisidine, and 2,3‐Xylidine

Synthesis, characterization, curing, thermophysical and mechanical properties of ethylene dichloride-based polysulfide polymers

Synthesis of Sulfonated Poly(phthalazinone Ether Sulfone)s by Direct Polymerization

Synthesis and Characterization of Thermooxidatively Stable Poly(dimethylsilyleneethynylenephenyleneethynylene) with O-Carborane Units

Synthesis of high molecular weight sulfonated poly(arylene ether sulfone) copolymer without azeotropic reaction