Abstract:This paper applies the computational fluid dynamics (CFD) simulation to study the condensate two-phase thermofluid characteristics of refrigerant HFO-1234yf flowing through horizontal straight and convergent passages for guiding the design of minitube heat exchangers. The theoretical analysis employs the volume-of-fluid (VOF) method to model the progression of film condensation process for determining the distributions of velocity, pressure, temperature, vapor volume fraction and film thickness for liquid-vapor interfacial flows. The Lee model is formulated as a user defined function to treat the phase change effect at the interface. The predictions of heat transfer coefficients and pressure drops agree reasonably well with the measured data from the referencing literature at the mass and heat fluxes of 200–800 kg/m2 s and 9.9–24.3 kW/m2 for validation of the computational model. The simulated results are presented to capture the complex two-phase flow behaviors during the film condensation progression, including the formation of interfacial ripples of annular films, wave-shaped films with elongated necking regions, shedding of liquid ligaments and breakup of these ligaments entrained into the vapor core. The VOF calculations also estimate the average heat transfer coefficient and pressure drop up to 11.3 kW/m2 K and 55.1 kPa at a mass flux of 800 kg/m2 s for the straight tube, showing similar thermal performance to refrigerant HFC-134a reported by open literature. The convergent passage essentially raises the average heat transfer coefficient and pressure drop because of more severe shear stresses over the film surface. The correlations of heat transfer coefficient and pressure drop are compared with CFD predictions for straight and convergent tubes. The performance assessment is thus conducted using the validated correlations to guide the redesign of minitube heat exchangers with HFO1234yf as an alternative refrigerant in various energy systems. Two design changes are presented using HFO1234yf refrigerant to enlarge the total surface area up to 13.49% in straight tubes or broaden the cooling surface area of only 6.4% in convergent tubes for matching the performance of R134a.

Pressure drop and heat transfer characteristics of clathrate hydrate slurry in a plate heat exchanger

Experimental Investigation on Evaporation Heat Transfer and Pressure Drop Characteristics of HFC-161 in a Horizontal Smooth Tube

Investigation on Thermal Conductive Consolidated Composite CaCl2 for Adsorption Refrigeration

Numerical Investigation of Heat Transfer Characteristics in a Shell- And-Tube Latent Heat Thermal Energy Storage System

Experimental Research on the Vapor Pressures of CaCl2–H2O and MgCl2–H2O As Working Fluids of Absorption Heat Transformers at High Temperature

Flow Boiling in Dimpled Plate Heat Exchangers with Different Geometric Parameters: Analysis of Asymmetric Channels

Cold energy transport and release characteristics of CO 2 +TBAB hydrate slurry flow with hydrate dissociation

Exploration of Dual-Phase Change Coupled Heat Transfer in Solar Regenerative Evaporator

The Effect of Microencapsulated PCM Slurry Coolant on the Efficiency of a Shell and Tube Heat Exchanger

Thermo-Hydrodynamics of a Helical Coil Heat Exchanger Operated with a Phase-Change Ice Slurry as a Refrigerant

Numerical investigation of hydraulic and heat transfer characteristics of two-phase ice slurry in helically coiled tubes

Heat transfer and pressure drop of film condensation in a horizontal minitube for HFO1234yf refrigerant

Heat transfer and pressure drop during condensation of low-GWP refrigerants inside bar-and-plate heat exchangers

Experimental study on heat/mass transfer and pressure drop of plate heat exchanger desorber for compact and efficient absorption cooling

Flow and heat transfer behaviors of phase change material slurries in a horizontal circular tube

Heat-transfer characteristics of the two-phase-change process between a microencapsulated phase-change-material-slurry droplet and air: A numerical study

Comparative experimental study on the thermal and hydraulic performances of capillary box heat exchanger and helical coil heat exchanger for surface water-source heat pump

Numerical analysis of phase-change material melting in triplex tube heat exchanger

Experimental assessment of a detachable plate falling film heat and mass exchanger couple using lithium bromide and water as working fluids

Heat Transfer, Energy Conversion, and Efficiency During Cold Discharge of a Novel Tetrabutylammonium Bromide Hydrate Cold Storage System

Study on flow and heat transfer characteristics of salt solution ice slurry