Abstract:This paper presents the initial developments of new hardware devices targeted for CAN (Controller Area Network) bus communications in forest machines. CAN bus is a widely used protocol for communications in the automobile area. It is also applied in industrial vehicles and machines due to its robustness, simplicity, and operating flexibility. It is ideal for forestry machinery producers who need to couple their equipment to a machine that allows the transportation industry to recognize the importance of standardizing communications between tools and machines. One of the problems that producers sometimes face is a lack of flexibility in commercialized hardware modules; for example, in interfaces for sensors and actuators that guarantee scalability depending on the new functionalities required. The hardware device presented in this work is designed to overcome these limitations and provide the flexibility to standardize communications while allowing scalability in the development of new products and features. The work is being developed within the scope of the research project “SMARTCUT—Remote Diagnosis, Maintenance and Simulators for Operation Training and Maintenance of Forest Machines”, to incorporate innovative technologies in forest machines produced by the CUTPLANT S.A. It consists of an experimental system based on the PIC18F26K83 microcontroller to form a CAN node to transmit and receive digital and analog messages via CAN bus, tested and validated by the communication between different nodes. The main contribution of the paper focuses on the presentation of the development of new CAN bus electronic control units designed to enable remote communication between sensors and actuators, and the main controller of forest machines.

Remote Measuring and Controling System Based on Ethernet and CAN Bus

Research of measurement and control for bearing based on distributed system

Remote Monitor and Control System Based on ARM9 and CAN Bus

EPA-based Open Network Control System

The Implementation and Performance Analysis of an Ethernet Embedded System Based on a Microcontroller

Design and implementation of controller for a sensor network protocol

The Design of the Embedded Bus Controller Based on the Network Monitor System

Design of Upper Computer System of High-End Loom Machine Controller Based on AT9261 and CAN Bus

Remote Monitor & Measurement Instrument System Faced To Internet Interoperable Service Of Manufacturing

Design and Application of CAN/LIN Gateway Controller in Automotive Body Network

Acquisition and Diagnosis Module for Vehicle Information Based on SAE J1939 Protocol

Design of Embedded PLC Based on ARM and CAN Bus

On-line Monitoring Device in Substation Based on the Technology of CAN Bus and ARM Microprocessor

Design and Implementation of a Smart Networking Control System for LED Lighting Based on CAN.

The design of electric motor car's body network based on CAN-bus distributed control

The Remote Fan Control Based on Real-Time Ethernet

Design of Data Arm Communication Based on CAN Bus

The Development of Embedded System Combining Inner CAN Bus and Outer Network Communication Protocol

Design of CAN Bus Communication Interfaces for Forestry Machines

Design and implementation of multi-channel CAN communication interface based on embedded Linux

Intelligent Control Network Design Based on CAN-bus for Audio Equipment