Abstract:Phenoxy acid herbicides are widely used because of their excellent efficiency and low cost. However, owing to their strong polarity and water solubility, these herbicides do not degrade easily in a water environment and persist for a long time in water bodies. These herbicides readily enter water bodies via surface runoff, infiltration, and other migration routes, thus affecting water quality safety. Therefore, it is of great significance to establish a sensitive and simple method for the quantitative analysis of phenoxy acid herbicides in environmental water. Given the low concentration of such contaminants in environmental water, appropriate detection methods are important. Ultra performance liquid chromatography-tandem mass spectrometry (UPLC-MS/MS) has high sensitivity and accuracy, thus being well suited for the phenoxy acid herbicides analysis. Sample preparation techniques are also important for the extraction and enrichment of contaminants in environmental water. Dispersive solid phase extraction (DSPE) has attracted considerable attention owing to its low cost, ease of operation, and low solvent consumption. In general, the selectivity and efficiency of solid phase extraction are largely dependent on the characteristics of the solid adsorbent materials. Ionic metal-organic frameworks (iMOFs) have excellent ion-exchange properties and show selective absorptivity to ionic compounds. In this work, a metal-organic framework (MOF) MIL-101-NH2 was synthesized by a facile hydrothermal method. Then, a cationic MOF mixed matrix membrane (MMM) was fabricated by soaking the MOFs in a polyvinylidene fluoride (PVDF) solution and further functionalization with quaternary amine groups. A method was developed for the determination of seven phenoxy acid herbicides in water by UPLC-MS/MS based on DSPE. The prepared material was characterized by Fourier transform infrared spectroscopy and scanning electron microscopy to determine its functional groups and morphology. The results showed that there were quaternary amine groups in the material, and that the functionalization did not have any obvious effect on the chemical and crystal structures of MIL-101-NH2. The prepared MIL-101-$NMe_{3}^{+}$-PVDF MMM was used as an adsorbent for DSPE to enrich the seven phenoxy acid herbicides in water. It is well known that the key factors influencing extraction efficiency are the adsorption and elution conditions. To establish the optimum extraction conditions, the influence of some important factors, including the adsorbent amount, sample pH, extraction time, elution solvent, elution volume, and elution time, was investigated in detail. Gradient elution was carried out with 0.01% formic acid aqueous solution and acetonitrile as the mobile phase. The target analytes were separated on an ACQUITY UPLC BEH C18 column (100 mm×2.1 mm, 1.7 μm), and multiple reaction monitoring (MRM) was conducted in the negative electrospray ionization mode. The external standard method was used for quantitative analysis. The established method was verified in terms of the linear ranges, limits of detection (LODs), limits of quantification (LOQs), recoveries, and precision. Under the optimal conditions, the seven phenoxy acid herbicides showed good linear relationships in their respective concentration ranges, and the correlation coefficients were all higher than 0.997. The LODs and LOQs were 0.00010-0.00090 μg/L and 0.00033-0.00300 μg/L, respectively. The recoveries were tested at three spiked levels of 0.005, 0.05, and 0.2 μg/L. The average recoveries of the seven compounds were in the range of 80% to 102%. The intra-day and inter-day relative standard deviations were within 1.4% to 9.4% and 4.2% to 12.6%, respectively. The established method was applied to the analysis of the phenoxy acid herbicides in tap water and reservoir water. Three levels of spiked samples were adopted to investigate the accuracy of the method. The results demonstrated that our method is applicable to the detection of trace phenoxy acid herbicides in water samples. In summary, this method has the advantages of simplicity, rapidity, and sensitivity, and it is suitable for the detection of the seven phenoxy acid herbicides in environmental water.

Trace Analysis of Phenols and Chlorophenols in Water by in Situ Derivatization Headspace Solid-Phase Microextraction Coupled with Gas Chromatography/Mass Spectrometry

Optimization of In-situ Derivatization Headspace Solid-phase Microextraction of Phenols in Water Using Response Surface Methodology

Simultaneous determination of nine trace mono- and di-chlorophenols in water by ion chromatography atmospheric pressure chemical ionization mass spectrometry

Development of A Solid-Phase Microextraction Fiber Coated with Poly(Methacrylic Acid-Ethylene Glycol Dimethacrylate) and Its Application for the Determination of Chlorophenols in Water Coupled with Gc

Trace Analysis of Phenolic Compounds in Water by in Situ Acetylation Coupled with Purge and Trap-Gc/ms

In-capillary solid-phase extraction-capillary electrophoresis for the determination of chlorophenols in water.

Development of a novel ultrasound-assisted headspace liquid-phase microextraction and its application to the analysis of chlorophenols in real aqueous samples.

LC-Ultrasound-Assisted Headspace Liquid Microextraction for the Analysis of Phenols in Water

Solid-phase Microextraction Based on Polyaniline Doped with Perfluorooctanesulfonic Acid Coupled to HPLC for the Quantitative Determination of Chlorophenols in Water Samples.

Sensitive measurement of ultratrace phenols in natural water by purge-and-trap with in situ acetylation coupled with gas chromatography-mass spectrometry

Salt-assisted Dispersive Liquid–liquid Microextraction Coupled with Programmed Temperature Vaporization Gas Chromatography–mass Spectrometry for the Determination of Haloacetonitriles in Drinking Water

Determination of Phenols in Soak Water from Drinking Water Related Products by Gas Chromatography-Mass Spectrometry with Large Volume Injection

Analysis of Bromophenols in Various Aqueous Samples Using Solid Phase Extraction Followed by HPLC-MS/MS.

Determing Ination of Phenols Compounds in Drinking Water by Double-Column Solid Phase Extraction-HPLC

[Determination of 4 phenols in water by three phase hollow fiber microextraction coupled with high performance liquid chromatography].

Analysis of trace-level nitrated polycyclic aromatic hydrocarbons in water samples by solid-phase microextraction with GC-MS.

Fast trace determination of nine odorant and estrogenic chloro- and bromo-phenolic compounds in real water samples through automated solid-phase extraction coupled with liquid chromatography tandem mass spectrometry

Multiresidue analysis of pollutants as their trimethylsilyl derivatives, by gas chromatography-mass spectrometry

[Determination of seven phenoxy acid herbicides in water by dispersive solid phase extraction-ultra performance liquid chromatography-tandem mass spectrometry based on cationic metal-organic framework mixed matrix membrane]

Rapid and simultaneous determination of ten off-flavor compounds in water by headspace solid phase microextraction and gas chromatography-mass spectrometry

Development of A Solid Phase Microextraction-Gas Chromatography-Mass Spectrometry Method for the Determination of Pentachlorophenol in Human Plasma Using Experimental Design