MEMS based digital variable capacitors with a high-k dielectric insulator

J.K. Luo,M. Lin,Y.Q. Fu,L. Wang,A.J. Flewitt,S.M. Spearing,N.A. Fleck,W.I. Milne
DOI: https://doi.org/10.1016/j.sna.2006.04.025
2006-01-01
Abstract:A novel MEMS based digital variable capacitor was designed and fabricated. The device consists of a multi-cantilever (or bridge) with variable length, suspended over a bottom electrode. By applying a voltage between the electrodes, the electrostatic force pulls the beams in one-by-one, realizing a digital increase in capacitance. A high-k dielectric HfO2 is also introduced to increase the capacitance value and tuning range. These devices were fabricated by a four-mask process, and electrical tests have confirmed the stepwise increase of the capacitance with bias. However it was found that it is difficult to pull-in more than 10 cantilevers and most of the cantilevers remained on the substrate when the bias is off. Charge injection from the pulled-in electrode into the insulator increases the pull-in voltage drastically, and prevents pulling-in more cantilevers. Trapped charges in the insulator produce an electrostatic force and keep the cantilever stuck on the substrate.
What problem does this paper attempt to address?