Abstract:With increasing of the geometry of various space structures, they easily bring low-frequency, longtime and more bending modal responses. Therefore, it is necessary to suppress effectually the vibration responses above. Adaptive structure design is a common method using the piezoelectric material. However, the conventional piezoelectric actuators hardly control effectually these responses owing to the inadequate actuated performance. This paper first introduces the design of a new dual-stack piezoelectric actuator, which has the bidirectional (can act in both push and pull directions) actuated advantage, using a pair of matching piezoelectric stacks within the actuator house. Two stacks are integrated in a mechanically opposing configuration and are electrically operated out of phase. Further, we design the piezoelectric bending actuator using two dual-stack piezoelectric actuators and a fixed device, and then a five-meter hoop truss can use it to perform the active vibration control. Here the truss is mainly applied to simulate a large hoop mesh antenna. Then, we set up the active control system based on the PD algorithm and build the simulation model by the Matlab/Simulink platform. The simulation results point out the PBA can produce enough actuated moment to suppress effectually the first-order modal response of the hoop truss. Finally, we perform three experiments including one uncontrolled case and two PD controlled cases. The two control cases mainly consider whether the driving voltages are offset or not. The experimental results of both control cases are in accordance with the better simulated analysis. The control ratios of the decay time of the first-order modal response are up to more than 30 percent in the simulations and experiments. That is, this bending actuator has good application foreground in controlling the bending modes of the spacecrafts with a larger size.

Experimental Study of Active Control for a Trussed Structure

DYNAMIC CONTROL OF TENSION STRUCTURES

Nonlinear active control of tensegrity structures

DYNAMIC ANALYSIS OF FLEXIBLE TRUSS WITH CLEARANCE JOINTS AND VIBRATION CONTROL BASED ON PIEZOELECTRIC ACTIVE STRUT

Research on force control theory of adaptive beam sting structure

Optimal displacement control of tensegrity structures based on linear programming

Dynamic Model of Flexible Structures with Twisted-and-Coiled Polymer Actuators

Intelligent vibration control of adaptive piezoelectric truss structure

Research on Deployable Truss Type Mast's Model Analysis and Its Active Vibration Control

Model reduction and active control of a trussed structure

A New X-Actuator Design for Controlling Wing Bending and Twisting Modes

PD control for vibration attenuation in Hoop truss structure based on a novel piezoelectric bending actuator

Active Vibration Control of Flexible Structures with Super-Coiled Actuators

Experimental Investigation of Auto Disturbances Rejection Vibration Control for Intelligent Truss Structures

Structural Seismic Active Control Test Study

Modified multi-mode positive position feedback controller for active vibration controlof a smart flexible structure

Active Vibration Control of a Hoop Truss Structure with Piezoelectric Bending Actuators Based on a Fuzzy Logic Algorithm

Study on Active Control of Structural Frequency Response

Experimental Study of Active Control for MDOF Seismic Structures

Dynamic Modeling and Vibration Control for a T-shaped Bending and Torsion Structure

Active Vibration Control Of Adaptive Truss Structure Using Fuzzy Neural Network