Abstract:The flyback converters are widely used in low power applications. The switch typically requires 600 V breakdown voltage in order to perform large step-down voltage. Thus, slight variation on the switch control can either permanently damage the switch or decrease the efficiency of the power conversion. In order to achieve higher power efficiency, the previous literature suggested operating the flyback converter in the discontinuous current mode (DCM). It is then required to understand the critical conditions of the DCM through analyzing the dynamic behavior and discontinuous current mechanism. This paper started from the current waveform analyses, proceeded to the derivation of zero current switching (ZCS) formulation, and finally reached the necessary conditions for the DCM. The entire DCM operation was divided into three phases that subsequently affect the result of the zero voltage switching (ZVS) and then to the ZCS. The experiment shows a power efficiency of over 96% when the output power is around 65 W. The switch used in this paper is a Gallium Nitride High-Electron-Mobility Transistor (GaN HEMT) that is advantageous at the high breakdown voltage up to 800 V. The important findings from the experiments include that the output power increases with the increasing input DC voltage and the duty cycle is rather linearly decreasing with the increasing switching frequency when both the zero voltage switching (ZVS) and ZCS conditions are satisfied simultaneously.

Design of a transition mode controller for flyback converters

A Multimode Digital Controller IC for Flyback Converter with High Accuracy Primary-Side Feedback

Design and implementation of off-line switching power-supply controller

Design and Simulation of a PFM-PWM Hybrid Controller for DCDC Converter with CLLC Topology

High-stability controller on CC or CV output applications

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

Multi-mode Controller IC for Soft-Switched Flyback Converter with High Efficiency over the Entire Load Range

Design of Multi-Mode Quasi-Resonant Fly-Back SMPS

Low Power Design of Multi-mode Switching Power Supply Controller IC

Dynamic Modeling and Controller Design for a Single-Stage Single-Switch Parallel Boost-Flyback–Flyback Converter

Evaluation of primary side control schemes for flyback converter with constant current output

Design of Single-flyback Switch Mode Power Supply Circuit with TOPSwitch-GX

Design Of A Cmos Integrated Controller With Variable Switching Frequency For High Current Low Voltage Dc-Dc Converters

Design of quasi-resonant flyback switch power supply

Design of Two-Switch Flyback Converter with CLC Output Filter

Discontinuous Current Mode Modeling and Zero Current Switching of Flyback Converter

Primary Side Detection and Peak Current Mode Control in Flyback Converter

A new flyback converter with primary side detection and peak current mode control

Study of a Multiple Output Flyback Converter Based on NCP1200A

Transformer design to achieve soft switching in low power Flyback converters

Seamless Mode-Switch Control Scheme for Primary Side Regulation Flyback with Capacitorless Self-Adaptive Startup