Abstract:Aerosol mixing state plays an important role in heterogeneous reactions and cloud condensation nuclei (CCN) activity. Organic surfactants could affect aerosol mixing state through bulk-surface partitioning. However, the mixing state of surfactant-containing particles remains unclear due to the lack of direct measurements. Here, direct characterizations of the mixing state for 20 kinds of submicron particles containing inorganic salts (NaCl and (NH4)(2)SO4) and atmospheric organic surfactants (organosulfates, organosulfonates, and dicarboxylic acids) were conducted upon relative humidity (RH) cycling by environmental scanning electron microscopy (ESEM). As the RH increased, the surfactant shells inhibited water diffusion being exposed to the inorganic core, leading to notably increased inorganic deliquescence RH (88.3 %-99.5 %) when compared with pure inorganic aerosol. Meanwhile, we directly observed an obvious Ostwald ripening process (that is, the growth of larger crystals at the expense of smaller ones) in 6 out of 10 NaCl-organic surfactant systems. As a result of water inhibition by the organic surfactant shell, Ostwald ripening in all systems occurred at RH above 90 %, which were higher than the reported RH range for pure NaCl measured at 27 degrees C (75 %-77 %). As RH decreased, eight systems underwent liquid-liquid-phase separation (LLPS) before efflorescence, showing a strong dependence on the organic molecular oxygen-to-carbon ratio (O : C). Quantitatively, LLPS was always observed when O : C <= 0:43 and was never observed when O : C > similar to 0:57. Separation RH (SRH) of inorganic salt-organic surfactant mixtures generally followed the trend of (NH4)(2)SO4 < NaCl, which is consistent with their salting-out efficiencies reported in previous studies. Solid-phase separations were observed after efflorescence for systems without LLPS. Our results provide a unique insight into the consecutive mixing processes of the inorganic salt-organic surfactant particles, which would help improve our fundamental knowledge of model development on radiative effect.

Investigation of A Modified Sinclair-La Mer Aerosol Generator in the Submicrometer Range

Size and Time-Resolved Growth Rate Measurements of 1 to 5 Nm Freshly Formed Atmospheric Nuclei

Design and Evaluation of an Aerosol Nanoparticle Generation System

Development of a Condensation Aerosol Generator

Effect of solute concentration on the number of NaCl particles generated by millimeter- and micron-sized droplets

Some Insights into the Condensing Vapors Driving New Particle Growth to Ccn Sizes on the Basis of Hygroscopicity Measurements

Electrical Mobility Spectrometer Using a Diethylene Glycol Condensation Particle Counter for Measurement of Aerosol Size Distributions Down to 1 Nm

Optimum Operating Parameters of an Evaporation-Condensation Submicron Aerosol Generator

Direct Observation for Relative-Humidity-dependent Mixing States of Submicron Particles Containing Organic Surfactants and Inorganic Salts

Sizing of Neutral Sub 3 Nm Tungsten Oxide Clusters Using Airmodus Particle Size Magnifier

Scanning Supersaturation Condensation Particle Counter Applied As a Nano-Ccn Counter for Size-Resolved Analysis of the Hygroscopicity and Chemical Composition of Nanoparticles

Developments for SAW-based aerosol generation: Miniaturized, cost-efficient, mass-producible, and reproducible systems

Design and performance of a single-pass bubbling bioaerosol generator

Factors That Govern Sub-3 Nm Particle Measurements in an Airmodus® PSM and a TSI® DEG–SMPS

A Spectrometer for Measuring Particle Size Distributions in the Range of 3 Nm to 10 Μm

Particle Charge Distribution Measurement for Commonly Generated Laboratory Aerosols

An Improved Monosize Droplet Generator for SMD Calibration

Methods for Determining Particle Size Distribution and Growth Rates Between 1 and 3 Nm Using the Particle Size Magnifier

A new particle size magnifier for detection of sub-2 nm particles

Condensation-type quasi monodisperse aerosol generator with WOx nanoparticles as nuclei produced by glowing wire method

Possible, impossible, and expected diameters and production rates of droplets in aerosols and sprays