Abstract:Abstract Most of the recent nanodevices are fabricated by using high-efficiency deposition methods and patterned via high-resolution lithography. However, there are drawbacks for the methods including small-scale product, high cost consumption, and multi-step processes. To reduce these disadvantages, this work focuses on the usage of sol-gel synthesis and spin coating method to fabricate ZnO seed layer onto glass substrates. All of substrates were patterned by conventional UV photolithography at exposure time of 7 seconds, then ZnO nanorods were hydrothermally grown at 90°C for 2, 3, and 4 hours, respectively. All of samples were characterised by scanning electron microscope (SEM) which revealed the sharp and smooth tip hexagonal structure at different hydrothermal time. The evolution of the nanorods’ growth was investigated, and the diameters were estimated. Moreover, crystal quality was revealed by x-ray diffractograms. It was clear that the domination of c-axis plane occurred for all the samples associates with the crystallinity of the nanostructures. This indicated escalating of the non-monodirectional growth plane in increasing nanorods’ diameter as the nanorods are polycrystal. Furthermore, the optical properties of the samples were observed by UV-visible spectroscopy and photoluminescence technique (PL). UV-visible spectroscopic data showed diminishing of the energy band gap when the diameter grew up. PL data revealed the reduction of the intensity ratio at near-band-edge peak versus oxygen vacancy peak. This information pointed to the decreasing trend of the crystal quality with escalating growth time.

Effects of Reaction Time on Morphologies and Photoluminescence Properties of ZnO Nanorods

Synthetic and Effect of Annealing on the Luminescent Properties of Zno Nanowire

Effect of Electrodeposition Time on Microstructure, Wettability and Optical Properties of ZnO Nanorod Arrays

Influence of Reaction Time on Spherical and Rod-like ZnO Nanocrystals

Effects of Electrodeposition Electrolyte Concentration on Microstructure, Optical Properties and Wettability of ZnO Nanorods

Effect of Solution Concentrations on Crystal Structure, Surface Topographies and Photoluminescence Properties of ZnO Thin Films

Effect of Reaction Temperature on Surface Morphology and Photoelectric Properties of ZnO Grown by Hydrothermal Method in Mixed Solvent

Effect of Cu Additions on Morphology and Optical Properties of ZnO Nanorod Arrays by Two-Step Method

Facile synthesis of Zn 1−x Cu x O nanorods with a very broad visible band

Temperature-dependent Photoluminescence of ZnO Nanorods Prepared by a Simple Solution Route

Low Temperature Synthesis and Optical Properties of Small-Diameter ZnO Nanorods

Straight and Thin ZnO Nanorods: Hectogram-Scale Synthesis at Low Temperature and Cathodoluminescence.

Preparation and photoluminescence of ZnO nanorods

Hydrothermal Synthesis of Well-Aligned ZnO Nanorod Arrays on Silicon

Effect of Reaction Time on the Morphology and Photocatalytic Property of ZnO Nanoparticles

Preparation and Photoluminescence of ZnO with Nanostructure by Hollow-Cathode Discharge

Photoluminescence Properties of Co-doped ZnO Nanorods Array Fabricated by the Solution Method

Temperature-Dependent Photoluminescence of Nanostructured ZnO

Hydrothermal Preparation and Photoluminescence Property of Co-Doped ZnO Nanorods

Size-Dependent Surface Effects on the Photoluminescence in Zno Nanorods

Influence of hydrothermal time on structural properties of ZnO nanorods grown on spin-coated ZnO seeding layer