Abstract:Al/SiC composites with volume fractions of SiC between 0.55 and 0.71 were made from identical tapped and vibrated powder preforms by squeeze casting (SC) and by two different setups for gas pressure infiltration (GPI), one that allows short (1–2 min) liquid metal/ceramic contact time (fast GPI) and the other that operates with rather long contact time, i.e., 10–15 min, (slow GPI). Increased liquid metal–ceramic contact time is shown to be the key parameter for the resulting thermal and electrical conductivity in the Al/SiC composites for a given preform. While for the squeeze cast samples neither dissolution of the SiC nor formation of Al4C3 was observed, the gas pressure assisted infiltration led inevitably to a reduced electrical and thermal conductivity of the matrix due to partial decomposition of SiC leading to Si in the matrix. Concomitantly, formation of Al4C3 at the interface was observed in both sets of gas pressure infiltrated samples. Longer contact times lead to much higher levels of Si in the matrix and to more Al4C3 formation at the interface. The difference in thermal conductivity between the SC samples and the fast GPI samples could be rationalized by the reduced matrix thermal conductivity only. On the other hand, in order to rationalize the thermal conductivity of the slow GPI a reduction in the metal/ceramic interface thermal conductance due to excessive Al4C3-formation had to be invoked. The CTE of the composites generally tended to decrease with increasing volume fraction of SiC except for the samples in which a large expansive drift was observed during the CTE measurement by thermal cycles. Such drift was essentially observed in the SC samples with high volume fraction of SiC while it was much smaller for the GPI samples.

Thermal properties of a high volume fraction SiC particle-reinforced pure aluminum composite

Thermal expansion and dimensional stability of Al–Si matrix composite reinforced with high content SiC

Microstructure and Thermal Conduction Property of SiCp/Al- Si Composite with High Reinforcement Content

Study of the residual stress distribution in SiCp/Al composites under thermal cycling conditions

The thermal expansion and mechanical properties of high reinforcement content SiCp/Al composites fabricated by squeeze casting technology

Thermal and Mechanical Properties of SiCp/Al Composite for Space Application

Effect of Silicon Addition and Thermal History on the Thermal Expansion Behavior of Sic/Al Composites

Mechanical and thermal expansion behavior of hybrid aluminum matrix composites reinforced with SiC particles and short carbon fibers

Influence of Reinforcement with Multimodal Distribution on Thermophysical Properties and Fracture Behavior in Al-Si/SiC Composites Infiltrated under Super-Gravity Field

Effect of thermal-cooling cycle treatment on thermal expansion behavior of particulate reinforced aluminum matrix composites

Thermal physical properties of squeeze casting SiCw/Al composite

Effects of Particle Size on the Thermal Physical Properties of Sicp/Al Composites

Effects of Particle Size on the Thermal Expansion Behavior of SiCp/Al Composites

Tailoring the thermophysical properties of porous SiC framework reinforced Al-Mg-Si composites by Si alloying content for thermal energy management

The Thermal Expansion Behaviour of SiCp/Al–20Si Composites Solidified under High Pressures

In-situ synthesis and microstructural evolution of a SiC reinforced Al-50Si composite exhibiting exceptional thermal properties

Effect of SiC Particle's Morphology on Thermal Conductivity and Thermal Expansion Properties of SiCp/Al Composites

Study on the Thermal Expansion and Thermal Cycling of AlNp/Al Composites

Influence of processing route on electrical and thermal conductivity of Al/SiC composites with bimodal particle distribution

Residual strain during low temperature fluctuation in some silicon carbide particulate reinforced aluminum composites

Study on Thermo-Physical Properties of New Type of Si_p/4032Al Composites