Abstract:The onset of pitting on high purity and ultra high purity aluminum has been studied in the micrometer range by using a microelectrochemical cell in order to evaluate influences that induce localized corrosion. Microelectrochemical tests on polished samples of Al 99.999 and Al 99.9999 in 1 M NaCl showed that pitting at large areas occurred at several hundreds mV more negative than at small areas, suggesting that even very pure Al contains weak points. On rough surfaces weak points are more “activated” than on smooth surfaces. Locally measured pitting potentials of polished samples were shifted to more positive values than those measured on ground samples. Larger areas contain always small scratches, even on polished samples. Hence, the surface roughness showed a minor influence on the onset of pitting on larger areas. Microelectrochemical measurements performed on pure Al 99.99 with small amounts of copper showed that a copper content below 30 ppm is too small to have a beneficial or detrimental effect, whereas a copper content above 300 ppm probably leads to the formation of small inclusions or precipitations that acted as preferential corrosion initiation sites. A copper content around 100 ppm showed a beneficial effect on very small areas but not on larger ones. The onset of pitting on high purity and ultra high purity aluminum has been studied in the micrometer range by using a microelectrochemical cell in order to evaluate influences that induce localized corrosion. In 1 M NaCl we tested the influence of the surface roughness, of the size of the exposed area , and of small amounts of alloyed copper.

A study on pitting corrosion of aluminum alloy 2024-T3 by scanning microreference electrode technique

Pitting Corrosion of Al2024-T3 in Sodium Chloride Solution

Microelectrochemical Studies of Pit Initiation on High Purity and Ultra High Purity Aluminum

Features of Electrochemical Noise During Pitting Corrosion of 2024-T3 Aluminum Alloy in 3.0% Na2SO4 Solution

Effect of pitting corrosion on fatigue and crack growth behavior of both aluminum alloy 2024-t 62 and its panel

Comparison Study on Machined Surface Integrity and Corrosion Resistance of 2024 Aluminum Alloy

ELECTROCHEMICAL FEATURES OF THE CORROSION OF AN ALUMINUM-LITHIUM ALLOY IN 3.0% NaCl SOLUTION

A Study on the Corrosion Fatigue Characteristics of Al 2024-T3 Alloy

Analysis of Pitting Corrosion Behavior of Pure Al in Sodium Chloride Solution with the Wavelet Technique

Prior corrosion and fatigue of 2024-T3 aluminum alloy

In Situ Atomic Force Microscopy Observations of the Corrosion Behavior of Aluminum‐Copper Alloys

The Relationship of High Strength Aluminum Alloy Corrosion Behavior and Corrosion Environment

Electrochemical noise features of pure aluminum during pitting corrosion in neutral NaCl solution

Studies on Pitting Corrosion of Al-Cu-Li Alloys Part II: Breakdown Potential and Pit Initiation

An assessment of pitting corrosion in anodized aluminum alloys: It might not be what it seems

Electrochemical noises of LC4, LY12 and pure Al in NaCl solution

Intermetallic Particles-Induced Pitting Corrosion in 6061-T651 Aluminium Alloy

Quantitative study of the corrosion evolution and stress corrosion cracking of high strength aluminum alloys in solution and thin electrolyte layer containing Cl-

Electrochemical Noise Study on 2024-T3 Aluminum Alloy Corrosion in Simulated Acid Rain under Cyclic Wet–dry Condition

Corrosion Behavior and Microstructure of 2024 Aluminum Alloy Sheets by Shot Peen Forming in a Salt Spray Environment

Corrosion pit-induced stress concentration in 7005 aluminium alloy: Mechanical degradation and pit parameter analysis