Abstract:Rectangular AT cut quartz resonators have been widely used in frequency control because of their smal size and extraordinary fequency temperature stability. However, a lot of spurious resonant modes such as face flexure, thickness twist, flexure and their higher order harmonics are coupled to the foundmental thickness shear mode at the edges of the plate. Traditionally only the modes propagating along the width direction are considered for two reasons. Firstly, the rectangular quartz plate dimensions used is often 2?mm×8?mm, that is, the length dimension is much larger than the width dimension. Secondly, the electrode has strong energy trap effect, which means that most of the vibration energy concentrates under the electrode. However, smaller resonators are developed recently, whose width and length dimensions are both less than 3?mm. So, it becomes necessary to take the modes propagating along both x 1 and x 3 directios into account. This paper presents the analysis of the vibration modes in AT cut quartz plate. According to Mindlin's 2 dimensional first order equations, dispersion curves for waves prorogating along x 1 and x 3 directions, in an infinite At cut quartz plate, are obtained. Moreover, after the boundary conditions are considered, standing waves are formed. Then the curves of dimensionless frqunency vs. length/thickness and width/thickness for rectangular AT cut quartz plates, i.e. mode charts, are given in this paper. There is excellent agreement between the computed results and the practical data from the factory. Finally, as an example, the design of a 4 MHz rectangular quartz resonator is shown in this paper. During the design of the resonator, the dimensions of both the width and length are carefully selected in order to avoid the existence of the spurious modes. At the same time, we can see that the computed results do not agree to the pratical data completely, especially at the high frequency range. We can improve the computed results in two ways. Firstly, because there are two correction factors in Mindlin's 2 dimensional first order equations, selecting proper correction may result in preciser mode chart. Secondly, FEM (Finite Element Method) is the desirable solution to the vibration problem of quartz resonator, because of its resilient adaptability to various boundary conditions and different cut orientations.

Modal Analysis of Practical Quartz Resonators Using Finite Element Method

An analytical and meshless modeling for vibration analysis of an infinite quartz resonator with non-circular electrodes

Analysis of Longitudinal and Torsional Resonance Vibrations of a Piezoelectrically Excited Bar by Introducing Piezoelectric Loss Coefficients

A Finite Element Simulation of Propagation Properties of Surface Acoustic Wave Resonator

Finite Difference Based Electrical Modeling and Vibration Control Simulation of Piezoelectric Structronic Plate System

An Original 2-D Analytical Model for Investigating Coupled Vibrations of Finite Piezoelectric Resonators

Method for QCM Resonator Device Equivalent Circuit Parameter Extraction and Electrode Quality Assessment

Electromagnetic analysis of thin film bulk acoustic resonator

Modeling the Piezoelectric Cantilever Resonator with Different Width Layers

Theoretical modeling of a circular piezoelectric actuator for micro-systems

Equivalent Electromechanical Model for Quartz Tuning Fork Used in Atomic Force Microscopy

Finite Element Method Design and Fabrication of Thermo-sensitive Quartz Tuning Fork Resonators as Temperature Sensor

Digital Simulation Model Design and Analysis of Piezoelectric Cantilever Beam Smart Elements

Design and Simulation of Quartz Resonant Accelerometer

Electromechanical Finite Element Analysis For Designed Low-Frequency Mems Piezoelectric Vibration Energy Harvester

Modal Simulation Calculation And Research Of Tuning Fork Based On Qepas System

THE VIBRATION ANALYSIS AND DESIGN OF AT-CUT RECTANGULAR QUARTZ RESONATORS

The Quality Factor of Quartz DETF for Resonant Sensors: Simulation, Analysis and Verification

Finite Element Analysis of Circular Quartz Resonators Using Scalar Differential Equation and Comsol

Quality factor measurement based on direct energy method for piezoelectric resonator

Force-frequency Coefficient of Symmetrical Incomplete Circular Quartz Crystal Resonator