Abstract:The paper addresses the method for stator and rotor resistance identification in speed sensorless induction motor drives. The instability problem caused by pure integration of the voltage model (VM) of rotor flux is handled by introducing correction terms in the VM. It is, however, shown that the third-order persistent excitation (PE) condition for simultaneous identification of stator, rotor resistances and rotor speed can barely be satisfied even with extra excitations in rotor flux modulus command. And an adaptive observer that is not persistently excited may become instable when exposed to bounded disturbances. Hence, to design a robust flux observer, concept of time-division multiplexing is incorporated into the observer design. That is, stator resistance is identified as the flux modulus is flat, while rotor resistance is adapted as a ramp flux modulus command is applied. This relaxes PE condition to order two, and as a drawback, the ramp flux modulus command incurs speed ripples. The decoupled identifiability of stator resistance is designed and explained, a rigorous input-to-state stability analysis of both the mismatch [between VM and current model (CM)] and the error (between actual rotor flux and CM) is set forth, and a convergence analysis of parameters is elaborated. To validate the feasibility, simulation and experiment results are included in the text as well.

Speed Sensorless DTC System Based on Full-order State Observer

Adaptive Robust Sensorless Control for PMSM Based on Improved Back EMF Observer and Extended State Observer

Speed-sensorless Direct Torque Control System of Induction Motor

Adaptive Sliding Mode Observer for Speed-Sensorless Control of PMSM

Feedback linearization control research of speed sensorless permanent magnet synchronous motor

Full-order Flux Observer Based on Speed and Stator Resistance Adaptation for Induction Motor

Backstepping Control of Speed for Sensorless Permanent Magnet Synchronous Motor

Extremely Low Speed Performance Research of the Speed Sensorless Vector Controlled Induction Motor Drive System

High Dynamic Sensorless Control for PMSMs Based on Decoupling Adaptive Observer

Speed Sensorless Vector Control Based on Full-order Adaptive Observer for Induction Motor Drives at Low Speed

Second-Order Sliding-Mode Observer With Online Parameter Identification for Sensorless Induction Motor Drives

Speed Sensorless Vector Control of Induction Motor Based on Full-Order Flux Observer

Online Decoupled Stator and Rotor Resistances Adaptation for Speed Sensorless Induction Motor Drives by a Time-Division Approach

Comparative Study Of An Adaptive Sliding Observer And An Ekf For Speed Sensor-Less Dtc Ipm Synchronous Motor Drives

Low Speed Stability Research of Adaptive Full-order Observer for Induction Motor

Sensorless Speed Control of PMSM Via Extended State Observer

Design Method of Adaptive Full Order Observer With or Without Estimated Flux Error in Speed Estimation Algorithm

Speed Sensorless Fuzzy Vector Control of Induction Motor Using an Adaptive Observer

Study of Adaptive Flux Observer and Speed Identification Method for Induction Motor

Accurate Flux Observer Based on Distributed Multi-Processor in MV Adjustable Speed Drive System

Robustness Improvement for Adaptive Full Order Observer in Sensorless Induction Motor Drives