Data Transfer Design Based on Link Port and USB

郭裕兰,欧建平

DOI: https://doi.org/10.3969/j.issn.1672-2892.2009.03.001

2009-01-01

Abstract:To meet the data transfer requirement between DSP and host PC in multi-DSP debugging system,by using FPGA as the timing controller,a data transfer system based on Link port and USB2.0 interface is designed.Link port is employed to realize the data transfer between the DSPs,and also between DSP and FPGA.USB2.0 is used as the interface between FPGA and host PC.The system structure is introduced,the chips selection,the timing design of Link port and FX2 chip are also finished.The design methods of firmware program,driver program and application program are presented.This system can work stably and flexibly,which can fulfill the data transfer task between ADSP-TS101 and host PC very well.