Abstract:The reactive adsorption of formic acid (HCOOH) on oxygen dosed Cu(110) has been studied using a molecular beam system, TPD, LEED and STM. At low temperature the reaction is strongly oxygen coverage dependent. All coverages result in high reaction probability (0.8 at room temperature) for formic acid and, for less than 0.25 monolayers of oxygen there is complete oxygen clean-off, leaving formate on the surface in a c(2 × 2) structure. At higher coverages the situation is more complex, with some oxygen remaining coadsorbed with the formate. The two adsorbates are then mainly phase separated into islands of c(6 × 2) oxygen and (3 × 1) formate. The two phases mutually compress each other due to pressure at the phase boundaries. The reaction stoichiometry is 2:1 formic acid:oxygen atoms in this temperature range. At higher temperatures (> 450 K) the formate itself is unstable and decomposes during adsorption which results in a change of stoichiometry of the reaction; one molecule of formic acid removes an oxygen atom as water, and hydrogen evolution ceases. There is a range of temperature between 350 and 420 K for which the reaction becomes very difficult, and the reaction probability drops to ∼ 0.1. It is proposed that this is due to rapid compression of much of the oxygen adlayer into the unreactive c(6 × 2) structure by small amounts of formate. The reaction proceeds through a highly mobile, weakly held, “precursor” state on the surface, which is able to seek out the active sites on the surface, which are low in coverage at high levels of oxygen. These active sites are the terminal oxygen atoms in the oxygen islands (in the [001] direction), which are only present at step edges or phase boundaries at 0.5 monolayers coverage of oxygen.

Thermogravimetry-Ftir Study Of The Surface Formate Decomposition On Cu, Cucl, Cu2o And Cuo - Correlations Between Reaction Selectivity And Structural-Properties

Adsorption and thermal chemistry of formic acid on clean and oxygen-predosed Cu(110) single-crystal surfaces revisited

Formic acid adsorption and decomposition on clean and atomic oxygen pre-covered Cu(100) surfaces

The adsorption and decomposition of formic acid on Cu {110}

Theoretical Insights into Structure Sensitivity in Formate Decomposition Dynamics on Cu Surfaces

SIMS Study of the Formic Acid Adsorption on Polycrystalline Copper and CuCl(111) Surfaces

TPD and IR Studies on the Decomposition of Formic Acid Adsorbed on ZrO2

Decomposition Mechanism of Formic Acid on Cu (111) Surface: A Theoretical Study

Density functional theory study on the atomic structure and electronic states of Cu(l00) (√2 × 2 √2)R45°-O surface

Density Functional Theory Study on the Atomic Structure and Electronic States of Cu(100) (2×22)R45°-O Surface

DFT and AIMD insights into heterogeneous dissociation of 2-chlorothiophenol on CuO(111) surface: Impact of H 2 O and OH

Thermally Activated Transformation of the Adsorption Configurations of a Complex Molecule on a Cu(111) Surface

Adsorption and Decomposition Mechanism of Formic Acid on the Ga 2 O 3 Surface by First Principle Studies

Thermal and Electrical Decomposition Products of C5F10O and Their Compatibility with Cu (1 1 1) and Al (1 1 1) Surfaces

Adsorption Performances for Aqueous Cu(II) onto Chelating Resin Dowex M-4195: Interaction Mechanism Investigation

A DFT Study on the Formation of CH3O on Cu2O(111) Surface by CH3OH Decomposition in the Absence or Presence of Oxygen

Conversion of Formic Acid on Single- and Nano-Crystalline Anatase TiO2(101)

Density functional theory study on the decomposition mechanism of HFC-32 on a Cu(1 1 1) surface: The impact of H2O and O2

Mechanism and Dynamics of CO 2 Formation in Formic Acid Decomposition on Pt Surfaces

Dissociative adsorption and linear organization of formic acid on ZnO(1 0 −1 0) surface

Heterogeneous reaction of formaldehyde on surface of alpha-Al2O3 particles