Improvements in evaluating constant-head permeameter test data

Jiannan Xiang
DOI: https://doi.org/10.1016/0022-1694(94)90005-1
IF: 6.4
1994-01-01
Journal of Hydrology
Abstract:The constant-head permeameter method has been used to determine the field-saturated hydraulic conductivity (Kfs) of unsaturated soils in the vadose zone for many years. This method was developed based on steady-state flow under a constant hydraulic head. The calculated Kfs values based on the classic analytical solution are much lower than those based on a numerical solution, whereas Kfs values based on the half-source solution provide a closer approximation of numerical results. Both the classic and the half-source solutions produce errors in evaluations of Kfs because the pressures evaluated by both solutions are correct only for the bottom of the borehole. By forcing the estimated pressures at the water surface and at the bottom of the borehole to be consistent with the actual pressures, a new solution is developed. Because Kfs is proportional to the shape factor C, which depends on the ratio of Ha, where H is the water height and a is the radius of the borehole, a comparison of the shape factors calculated based on different solutions was conducted. Results show that the proposed method is simpler and provides C values closer to actual numerical results than do the other solutions for the range Ha = 1–10, although the Philips method can provide a good estimation as well. To show the relative accuracy of the proposed solution, the total water pressure on the surface of the borehole is also compared using different solutions. Results show that the proposed solution agrees with the pressure distribution on the borehole surface better than do the other solutions for the range Ha = 1–10. The unsaturated effect on the calculated Kfs is significant, but the method developed by Reynolds et al. (Soil Sci. Soc. Am. J., 139: 172–180, 1985) and Reynolds and Elrick (Soil Sci. Soc. Am. J., 140: 292–302, 1985a) may provide an unrealistic negative parameter when soil heterogeneity is strong. To avoid tests conducted in strongly heterogeneous soils, equations to evaluate the maximum and minimum flow rate ratios are proposed.
What problem does this paper attempt to address?