Abstract:Accurate detection of the internal decomposition components of SF6 electrical equipment plays an important role in the evaluation of equipment status. However, gas samples are usually taken out for detection at present, which makes it difficult to understand the real situation inside the equipment. In this paper, a carbon nanotube-coated fiber gas sensor is proposed, which has the potential to be applied as a built-in gas sensor. The fiber loop ring-down (FLRD) gas detection system based on the carbon nanotube-coated fiber gas sensor was built, and the detectable decomposition components among the four typical SF6 decomposition components of SO2, SO2F2 and SOF2 and CO were analyzed. The results showed that the fiber gas sensor was most sensitive to CO. Based on density functional theory, it was found that single-walled carbon nanotubes had the best adsorption effect on CO molecules under the same conditions, with the adsorption energy reaching −0.150 Ha. The detection performance of the system for CO was studied, and the results showed that there was a good linear relationship between CO concentration and ring-down time: R2 was 0.984, the maximum inversion error of 0~200 ppm CO was 1.916 ppm, and the relative error was 4.10%. The sensitivity of the system was 0.183 ns/ppm, and the detection limit of the system was 19.951 ppm. The system had good stability, with the standard deviation of single-point repeatability being 0.00356, and the standard deviation of the long period of the experiment being 0.00606. The research results provide a new idea for the detection of SF6 decomposition components, and lay the foundation for the component detection method of built-in fiber sensor of SF6 electrical equipment.

Experimental Study of Carbon Nanotubes Gas Sensor Detecting SF_6 Partial Discharge Decomposition Components

Study on Gas Sensing Property of Metal Particle Doped Multi-Walled Carbon Nanotubes

Ni-CNT Chemical Sensor for SF6 Decomposition Components Detection: A Combined Experimental and Theoretical Study

Nanocomposites of Carbon Nanotube (cnts)/cuo with High Sensitivity to Organic Volatiles at Room Temperature

Experimental Study of Carbon Nanotubes Gas Sensor Based on Corona Discharge

Preparation of CNTs/PANi core/shell-structured nanowires and improvement of sensitivity of chemical sensors

Study of Carbon Nanotubes Gas Sensor Based on Stochastic Resonance

Experimental Study Of A Novel Aligned Carbon Nanotubes Gas Sensor

Carbon Monoxide Detection Based on the Carbon Nanotube-Coated Fiber Gas Sensor

Adsorption Behavior of N<inf>3</inf>-CNT Towards SF<inf>6</inf> Decomposed Species: a DFT Study

Carbon Nanotube Gas Sensor Based on Corona Discharge

Fabrication of Carbon-Nanotube Sheet Based Hydrogen Sensor

Research Advances of Carbon Nanotube-based Gas Sensors

Toward Practical Gas Sensing with Rapid Recovery Semiconducting Carbon Nanotube Film Sensors

Room-Temperature Detection of SF6 Decomposition Byproducts Using a G-C3n4@sno2-zno Composite Sensor

Study of a novel aligned carbon nanotubes gas sensor based on gas discharge

Low-Temperature Monitoring of SF6 Decomposition Products Based on CeO2@MWCNTs Composite Sensor

Wafer-Scale Field-Effect Transistor-Type Sensor Using a Carbon Nanotube Film as a Channel for Ppb-Level Hydrogen Sulfide Detection

Room-Temperature Flexible CNT/Fe 2 O 3 Film Sensor for ppb-Level H 2 S Detection

A Flexible NO2 Gas Sensor Based on Single-Wall Carbon Nanotube Films Doped with a High Level of Nitrogen

WS2 Nanostructure-Based Gas Sensor for SF6 Decomposition Products: Experimental and First-Principles Study