Abstract:In a regular FAIMS system, a carrier gas is used to drive samples through the drift tube. Thus, high consumption of sample and carrier gas can be expected, especially when multi-cycle detection is needed for high precision detection. In this study, a novel re-circulation mode FAIMS was developed. Ion separation capacity and limit of detection (LOD) of this FAIMS system were investigated. The stability of this FAIMS system was also studied by changing the flow rate of the carrier gas. Using this newly designed re-circulation mode FAIMS system, the detection results of o-, p- m- xylenes in pure nitrogen and helium/nitrogen mixtures were compared. The sample and the carrier gas reserve time which ensure the success of multi-cycle detection was examined. The characteristic parameters (alpha(2), alpha(4)) and their deviation were also precisely calculated through 18 CV-DV spectra. Results show that 0.6 ng o-xylene can be detected in a 25 ml closed loop re-circulation arrangement. The effective detection time is 6.2 min in this detection process. In fact, the sample and the carrier gas used in this experiment are 70 and 826 times less than a regular open loop FAIMS system respectively. The peak position and the full width at half-maximum (FWHM) of the obtained CV-DV spectra stay almost unchanged during th.entire experiment process. The ion signal peaks can be fitted with a Gauss curve, which means that the stability of the carrier gas flow rate fully meet the requirement for on-site detection. Furthermore, the use of a helium modifier is studied and proved to be an effective method to improve the detection capacity of the FAIMS for VOCs. In conclusion, the gas-saving re-circulation design along with the gas modifiers provide new opportunities for FAIMS systems to be applied on-site high precision chemical detection. (C) 2016 Elsevier B.V. All rights reserved.

The development of a gas-filled time-of-flight detector

Gas Modifier Assisted Re-Circulation Mode High-Field Asymmetric Waveform Ion Mobility Spectrometry (FAIMS)

Developments In Accelerator Mass Spectrometry (Ams) Method For Hf-182

Plastic Scintillation Detectors for Precision Time-of-Flight Measurements of Relativistic Heavy Ions

Detection of 36 Cl with Accelerator Mass Spectrometry

Detection of correlated fission fragments with a twin Frisch-grid ionization chamber

Time-of-flight detectors with improved timing performance for isochronous mass measurements at the CSRe

Efficiency and rate capability studies of the time-of-flight detector for isochronous mass measurements of stored short-lived nuclei with the FRS-ESR facility

Data Acquisition System with Pulse Height Capability for the Tofed Time-Of-Flight Neutron Spectrometer

Construction of high-resolution energy—time-of-flight spectrometer for determination of fission fragment mass distributions

Development of an "$α$-ToF" detector for correlated measurement of atomic masses and decay properties

A Time-of-flight System for the External Target Facility

Development of an Ion Store/Time-of-Flight Mass Spectrometer for the Analysis of Volatile Compounds in Air

Electrostatic-lenses position-sensitive TOF MCP detector for beam diagnostics and new scheme for mass measurements at HIAF

TOF spectroscopy measurement using waveform digitizer

New trapezoid-shaped Frisch-grid ionization chamber for low-energy particle measurements

A linear time-of-flight mass analyzer for thermal ionization cavity mass spectrometry

Cosmic Ray Test of a STCF DTOF Detector Prototype

Readout Electronics Prototype of TOF Detectors in CEE of HIRFL

Design and Construction of a Time-of-flight Wall Detector at External Target Facility of HIRFL-CSR

A Data Analysis Method for Isochronous Mass Spectrometry Using Two Time-Of-Flight Detectors at Csre