Abstract:P-doped TiO2 nanoparticles were synthesized by the sol-gel method with various H3PO4 amounts. The samples were calcinated at different temperature and charactered by XPS, ICP, XRD, SEM, Raman, FTIR, and UV-vis methods, so that the formation process of phosphate species could be inspected. The XRD results show that P species hinder the particle growth of anatase and increase the anatase-to-rutile phase transformation temperature to more than 900 degrees C, and a new titanyl phosphate, Ti5O4(PO4)(4), was observed in P-doped TiO2 when calcined at 1000 degrees C. The UV-vis results indicate that the P species is likely to have two different states, leading to the variety of visible-light photocatalytic activity and band gap energy of P-doped TiO2. One state is the "separated phase". In this state, the P/Ti ratio is very low so that the P species is surrounded by TiO2. The "separated phase" of P species introduces oxygen into TiO2 lattice and hence causes a red-shift of the adsorption band edge of anatase, leading to the increased visible-light photocatalytic activity of P-doped TiO2. The other state is the "congregated phase". It appears at the micro region where the ratio of P/Ti is high enough to make the TiO2 clusters isolated by P species. The "congregated phase" of P species acts as the interface phase between TiO2 clusters and strongly retards the crystal growth of anatase, resulting in the widened band gap of P-doped TiO2. Furthermore, a possible mechanism was also proposed to explain the formation of the two phases during the sol-gel process. The results indicate that in order to improve the visible-light photocatalytic activity of P-doped TiO2 the percentage of "separated phase" in P species needs to be enhanced.

Photocatalytic Activity of Nano-Tio2 Codoped with Boron and Fe2O3 in Visible Region

Visible-Light-Driven Titania/Silica Photocatalyst Co-Doped with Boron and Ferrum

Visible-light-driven Boron/ferrum/cerium/titania Photocatalyst

Photocatalytic Activity of Iron Doping Tio2 Prepared by Several Methods

Fabrication of V-Doped TiO2 Nanoparticles and Photocatalytic Studies under Visible Light

P-doped TiO2 Immobilized Diatomite and Its Photocatalytic Performance under Visible Light

Photonic, and Photocatalytic Behavior of Tio2 Mediated by Fe, Co, Ni, N Doping and Co-Doping

Preparation of Nanoparticle WO_3-doped TiO_2 and Research on Its Photocatalytic Activity

Preparation Of Fe3+-Doped Tio2 Nanoparticles And Their Photocatalytic Activities

Nanocrystalline Fe/TiO2 Visible Photocatalyst with a Mesoporous Structure Prepared via a Nonhydrolytic Sol-Gel Route

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

Preparation and Photocatalytic Activity of Nanoparticle Fe/TiO2 by Chemical Precipitation Method

Study on the Preparation and Photocatalytic Property of N, Fe, Zn Nano-TiO<sub>2</sub> Loaded on Active Carbon

Preparation and Visible Light Photocatalytic Activity of Nitrogen-doped Nano-TiO_2 Powders

Photocatalytic Properties of TiO<sub>2</sub> and Fe(III)-, Z(II)- and Si(IV)- Doped TiO<sub>2</sub> Nanopowders Synthesized by Sol-Gel

Visible Region Photocatalysis of Ce-Si/Tio2 Synthesized Using Sol-Gel-Hydrothermal Method

Sol-Gel Hydrothermal Synthesis and Visible Light Photocatalytic Degradation Performance of Fe/N Codoped TiO2 Catalysts

F and Fe co-doped TiO<sub>2</sub> with enhanced visible light photocatalytic activity

Preparation and Characterization of Visible-Light-driven TiO2 Photocatalyst Co-doped with Nitrogen and Erbium.

F and Fe co-doped TiO 2 with enhanced visible light photocatalytic activity

Efficient degradation of toxic organic pollutants with Ni2O3/TiO(2-x)Bx under visible irradiation.