Abstract:Herein, three different tool steels are fabricated by additive manufacturing and conventional methods. Subsequently, their softening resistance and abrasive wear resistance are evaluated and compared. In the end, the correlation between hardness, wear resistance, and microstructural characteristics is created. Directed energy deposition (DED) is a powerful method for hard‐facing the existing tool components. Herein, three tool steel grades including a newly developed maraging steel (NMS), a cold work tool steel (V4E), and a high boron steel (HBS) are cladded on a hot work tool steel substrate. After tempering, the cladded tool steels are exposed to high temperatures at 600, 700, and 800 °C for 3 h to evaluate their softening resistance. The results show that all three tool steel grades have a significant hardness drop when the softening temperature reaches 700 °C. The investigated NMS has the lowest initial hardness in the tempered state but the best softening resistance. In contrast, HBS has the highest initial hardness but the worst softening resistance among the three steel grades. V4E tool steel has a moderate softening resistance compared to the other two steel grades. The factors contributing to the softening resistance have been discussed. Corresponding conventional tool steels are also adapted as references for comparison. Except for the NMS, the additive manufacturing tool steel samples have a better softening resistance than the conventional counterparts owing to more alloying elements trapped in the matrix. The abrasive wear resistance of the tempered and softened tool steels manufactured by DED and conventional methods is also evaluated and the wear mechanism is discussed. Besides the hardness, the free spacing λ between coarse hard particles is one of the major factors influencing the abrasive wear resistance.

Properties Requirement and Alloy Design for Organic Matter Cutting Tool Steel

Effect of Carbon Content and Elements Mo and V on the Microstructure and Properties of Stainless Steel Powder Surfacing Layer

A Newly Designed High-Strength Tool Steel with High Wear and Corrosion Resistance

The Properties of 1500 Mpa Grade Alloy Steel with Carbide Free Bainite/Martensite Mixed Microstructures

Optimizing Design of the Cutting Tool in Cutting of Ultra-High Strength Steel Beam Part

Development and Application of Cemented Carbide Used in 30crmnsia High-strength Alloy Steel Processing

Comparison of Softening Behavior and Abrasive Wear Resistance between Conventionally and Additively Manufactured Tool Steels

As-cast Microstructure of High-boron Middle-carbon Alloy Tool Steel

Microstructure Characteristics and Wear Performance of a Carburizing Bainitic Ferrite + Martensite Si/Al-Rich Gear Steel

Design of Low Hardness Abrasion Resistant Steels

SELF-RELIANCE INNOVATION ON DEVELOPMENT OF ULTRA-HIGH STRENGTH STEEL

Microstructure Characteristics and Wear Performance of a Carburizing Bainitic Ferrite plus Martensite Si/Al-Rich Gear Steel

Tailoring Heterogeneous Microstructure in a High-Strength Low-Alloy Steel for Enhanced Strength-Toughness Balance

Revealing the mechanism of extraordinary hardness without compensating the toughness in a low alloyed high carbon steel

Analysis of Numeric Control Processing Technology for High Strength and High Chrome Oil Well Steel Tubing

Relationship of microstructure on the mechanical and splitting fracture properties of a high carbon forging steel for connecting rod

Material and processing optimization on disc cutter of tunnel boring machine for failure prevention

Mechanisms of Strengthening and Toughening of Austempered High Silicon Cast Steel

An investigation on wear mechanism of high-speed turning of free-cutting steel AISI 1215 using uncoated and multi-layer coated tools

Microstructure and Hardening Behavior of Al-modified Fe-1.5 Wt%b-0.4 Wt%c High-Speed Steel During Heat Treatment

Coarse Grained Heat-Affected Zone Microstructure and Brittleness of Ti-Nb-B Microalloyed High Toughness and Wear Resistant Steel