Abstract:Novel energy generation technologies, such as high-permeability wind power and photovoltaic systems, exhibit inherent intermittency, randomness, and volatility. During periods of energy production from these sources, the impedance of the electrical grid frequently experiences significant fluctuations. Consequently, the grid manifests characteristics akin to a weak grid, highlighting the challenges associated with integrating renewable energy sources with variable output profiles. These fluctuations lead to a shift in resonance spikes of the LCL-type filter towards the lower frequency band, consequently impacting the stability of inverter grid connections. To mitigate this issue, the present study introduces a novel approach integrating the D-split method and a proportional–differential feedforward strategy. This combination aims to reshape the inverter's output impedance, ensuring its consistent stability even amidst significant fluctuations in grid impedance. In this research, the optimal controller parameters for systems operating under robust grid conditions are initially determined. This selection process involves the application of the D-split method, supported by graphical visualization. Additionally, the amplitude and phase angle margin tester is employed while considering the system bandwidth as a limiting constraint. Moreover, accounting for the influence of grid impedance, the D-split method is reapplied to ascertain the most suitable values for the proportional–differential feedforward parameters. This adjustment aims to enhance the adaptability of the grid-connected inverter specifically in scenarios characterized by a weak grid. The hardware-in-the-loop (HIL) simulation results demonstrate that despite the presence of harmonics within the grid and a short circuit impedance ratio (SCR) of 3, the inverter maintains grid stability and effectively suppresses harmonics. Moreover, the total harmonic distortion factor (THD) of the grid-connected current remains below 5%.

Design of 5th Harmonics Restraintable Line-Connected Inverter for Connection of Distributed Generation System with Power Grid

The Harmonic Control Used in Grid-connected Inverter Based on DSP

Design of Grid-tied Inverters with the Functions of Reactive and Harmonic Compensation

Inverter Admittance Phase-Reshaping Strategy for Enhancing Its Robustness to Grid Impedance.

Robust Control for Single Phase Grid-connected Inverters

Design and analysis of an LCL circuit-based three-phase grid-connected inverter

Current Harmonics from Single-Phase Grid-Connected Inverters—Examination and Suppression

Implementation of Inverter Incorporated in Power Network Based on Voltage Phasor Diagram

Design of Single-phase Low-power Grid-Connected Inverter for Distributed Generation

Suppression of Voltage Harmonics in Single-Phase Inverters Based on Multi-Voltage Control

Application of Virtual Synchronous Generator Technology in Three-Phase Four-Leg Inverter

A New Synchronization Algorithm for Grid-Connected Inverters

Current Harmonic Suppression For Grid-Connected Vsg Based On Virtual Harmonic Impedance

Improved Control Strategy of Grid Connected Inverter Without Phase Locked Loop on PCC Voltage Disturbance

Direct Power Control of Doubly Fed Induction Generator Without Phase-Locked Loop under Harmonically Distorted Voltage Conditions

Improved DPC Strategy of Grid-Connected Inverters under Unbalanced and Harmonic Grid Conditions

A Synchronization Method for Single-Phase Grid-Tied Inverters

An Accurate Power-flow Control Method with Harmonic Compensation in Voltage-source-inverter Grid-tied System

Design of Photovoltaic Grid-Connected Inverter Control

A Series Impedance Reshaping Control Method Considering PLL Dynamics for Grid-Connected Inverters under Weak Grid Conditions

Designing Parameters to Reshape the Inverter Output Impedance Based on the D-Split Method under Weak Grid Conditions