Catalytic Hydrolysis of Waste Nylon 6 to Produce Ɛ-Caprolactam in Sub-Critical Water

Jinyang Chen,Guiyang Liu,Lujiang Jin,Pei Ni,Zhi Li,Haibo He,Yi Xu,Jianqiu Zhang,Junping Dong

DOI: https://doi.org/10.1016/j.jaap.2009.10.004

IF: 6

2010-01-01

Journal of Analytical and Applied Pyrolysis

Abstract:The wide use of nylon 6 (PA 6) resulting in the resource recovery of waste PA 6 is urgent and its hydrolysis in sub-critical water to produce ɛ-caprolactam is a very important method. Hydrothermal diamond anvil cell (HDAC) was used to in situ observe transformation of PA 6 in water up to 513K. The result shows that PA 6 melts at 488K, and then hydrolyzes to produce low molecular dissoluble compounds such as 6-aminocaproic acid and ɛ-caprolactam from cleavage of acyl–amido bond. Different from the microreactor (about 0.075μl) of HDAC, degradation of PA 6 in hydrothermal vessel of 18ml is far slow, so the higher temperatures of 553, 573, 583, and 603K are tried. As for hydrothermal vessel runs, liquid products after degradation are mainly composed of ɛ-caprolactam. Phosphotungstic heteropoly acid (HPA) as catalyst can improve hydrolysis rate and yield of ɛ-caprolactam, and 3% HPA can attain preferable effect. The optimum hydrolysis conditions for ɛ-caprolactam are as follows: HPA amount is 3%, reaction temperature is 573K and reaction time is 85min, and the yield of ɛ-caprolactam is 77.96%. In the temperature range of 553–603K, the non-catalytic and catalytic degradation kinetics are studied as pseudo-first-order reaction and apparent activation energy is 86.64 and 77.38kJ/mol for no catalyst and 3% HPA, respectively.