Abstract:The AC losses, the current density and the magnetic field are important variables to design devices made of High Temperature Superconductors (HTS). These variables are often numerically computed using a transient finite element analysis even though the interest may lay in the steady-state regime of the device. The need for solving time-dependent variables has led to improve the computation time with efficient finite element models (FEM) relying on different formulations. These transient FEM are computationally slow and demanding in terms of resources. In the present work, an alternative path is taken with the development of a frequency-domain FEM using a phasor representation to alleviate the computation burden. This model does not have the versatility of the transient models. However, it can generate the initial steady-state conditions for a subsequent transient analysis. It is perfectly adapted to study the steady-state regime of HTS devices operated in AC conditions. In this phasor modelling approach, the Root Mean Square (RMS) resistivity of the superconductor is introduced. It is subsequently approximated by an exponential function introducing a factor to ease its implementation in the commercial software COMSOL Multiphysics with the most recent and fastest formulations T-A and J-A. The case studies encompass single BSCCO and REBCO tapes as well as a CORC cable or specifically, in the present work, a CORT (Conductor on Round Tube). The results of the time- and frequency-domain FEM simulations are compared against experimental data. The comparison of the models' results is carried out comparing the current density distributions as well as the AC losses. The comparison against experimental data is only conducted on the AC losses. In the present case, it is used to quantify thoroughly the accuracy of the numerical results compared to the measurements. A reasonable agreement between those results and the experimental data was found.

FINITE ELEMENT METHOD ANALYSIS OF HIGH TEMPERATURE SUPERCONDUCTORS POWER LOSS AND THE RELEVANT PROBLEMS DISCUSSION

Numerical Analysis on the Current Distribution and the Loss in HTS Stacked Tapes Considering Termination Resistances

Computation of Losses in HTS Under the Action of Varying Magnetic Fields and Currents

Calculation Of Ac Losses In Hts Tape With Fea Program Ansys

An Investigation on AC Loss Reduction for Permanent-Magnet Superconducting Electrical Machine

A frequency-domain finite element model for simulating high-temperature superconductors using the J-A and T-A formulations

Study on the Influence of Skin Effect on AC Loss of YBCO Tape

The stability of the high temperature superconducting DC coils with defects

Numerical models for AC loss calculation in large-scale applications of HTS coated conductors

Effect of local and global screening current on the current decay in closed-loop HTS coils

An Experimental Investigation of Critical Current and Current Distribution Behavior of Parallel Placed HTS Tapes

3-D Modeling of AC Loss in D-Shaped HTS Coils Using and - Formulation-Based Finite Element Methods

Numerical Modeling of AC Loss in HTS Coated Conductors and Roebel Cable Using T-A Formulation and Comparison With H Formulation

The Numerical Study of Influence of Flux Creep on AC Losses in Superconductors

Analyzing Dynamic Resistance in High-Temperature Superconducting Tapes by Combining Finite Element Method with Machine Learning

Investigation of AC Loss in HTS Cross-Conductor Cables for Electrical Power Transmission

Electromagnetic Field Analysis and Optimization Method of High-Temperature Superconducting Transformer under the Influence of Abnormal Voltage

Numerical calculations of high temperature superconductors with the J-A formulation

Strain dependence of critical current and self-field AC loss in Bi-2223/Ag multi-filamentary HTS tapes: a general predictive model

Simulation of Current Profile and AC Loss of HTS Winding Wound by Parallel-Connected Tapes

Optimization of HTS Transformer Parameters and Analysis of AC Losses Under Harmonic Conditions