Abstract:Raman fiber amplifiers (RFAs) have become increasingly important in optical communication systems and optical networks to compensate for the fiber loss and/or splitting loss. Comparing to the conventional rare-earth doped fiber amplifiers, RFAs have flexible signal gain band and low noise figure (NF) level [ 1].Recently, we reported an RFA with signal/pump double-pass the gain medium scheme by utilizing an optical circulator (OC) as a signal/pump reflector [7]. The experiments have successfully confirmed that the pumping efficiency improvement for this kind of RFA is more efficiency than other types of RFAs. What's more, the pumping efficiency improvement and the NF suppression can be realized simultaneously. Although it is crucial to numerically predict the characteristics of RFA such as signal power and noise figure (NF) versus pump wavelength, pump power, gain medium characteristic and so on, the optimum design of RFA parameters has not yet been addressed.In this paper, we preliminary describe the numerical simulation method based on a set of coupled steady-state equations to estimate the characteristics of signal/pump double-pass RFA. First we assume that the ASE level combines other noises is 30 dB lower than that of the input signal [8], so only the forward and backward signal/pump are considered. This is a typical boundary condition problem and Newton method is used. As we get the distribution of pump power and signal power along the DCF, the noise item at different frequency can be found by the relaxation method. After several iterations, all WDM channel signals and noise are convergent as predict. In this paper, in order to optimize the length of the DCF to get the best performance, we suggest a proper definition of NF called effective NF. During the simulation, the length of SMF is kept constant, so DCF length becomes the only dominant variable parameter to affect the gain and NF of the RFA. To verify the algorithm above, the parameters are set equal to those in Ref. [7], and the simulation results are in very good agreement with those of experimental data. To show the optimum DCF length under a fixed pump power and pump wavelength, we calculate results of both the signal output power and NF versus DCF length at three signal wavelengths. We find that the largest signal output power may appear at the length of DCF is 3.6 km, and the lowest NF could be found as the DCF length is 4 km. In general, DCF has a larger gain coefficient than that of the SMF, but the attenuation coefficient of the former is also higher than that of SMF. So, there is a trade-off when selecting the length of DCF. From the simulation results, we conclude that the optimum length of DCF is 3.8 +/- 0.2 km. DCF length of around 3.8 kin is an ideal value to realize the best characteristics for the RFA.

Parameters Optimization of High Efficiency Discrete Raman Fiber Amplifier by Using the Coupled Steady-State Equations

Parameters Optimization of A High Efficiency Discrete Raman Fiber Amplifier

Design of Raman-Parametric Fiber Amplifier for Wavelength Division Multiplex Transmission System

Improvement in characteristics of a distributed Raman fiber amplifier by using signal-pump double-pass scheme

A Flattening Gain Raman Amplifier Involved Only 2 Cascaded FBG Based Multi-Wavelength Pumps

Transmission Performance Analysis of Fiber Optical Parametric Amplifiers for Wdm System

Performance Analysis and Comparison of Bi-directionally Pumped Raman Amplifiers

Fiber-bragg-grating-based dispersion-compensated and gain-flattened raman fiber Amplifier.

Design Gain Characteristic Of Dual-Pump Fiber Raman Amplifier

Optimal Design Of Flattened Gain Spectrum Of Raman Amplifiers Based On Photonic Crystal Fibers

Flexible Raman Amplifier Optimization Based on Machine Learning-aided Physical Stimulated Raman Scattering Model

Numerical Investigation of Raman-Assisted Four-Wave Mixing in Tapered Fiber Raman Fiber Amplifier

Optical Fiber Amplifiers: Optimization and PerformanceEvaluation

Optimal Design and Analysis of Broadband Fiber Raman Amplifier

Novel Methods for Fast Fiber Raman Amplifier Pump Configuration

Polarization dependent gain in Raman fiber amplifiers with multiple pumps

Optimal Design for Bidirectionally Pumped Raman Transmission Systems

Linear Regression Method for Wide-Band Flat-Gain Fiber Raman Amplifier Pump Power Automatic Configuration

Influence of Bragg Reflection of Chirped Tilted Fiber Bragg Grating on Raman Suppression in High-Power Tandem Pumping Fiber Amplifiers.

Distributed Raman Amplification for Fiber Nonlinearity Compensation in a Mid-Link Optical Phase Conjugation System

Optimal Design Algorithm for Bi-Directionally Pumped Raman Amplifiers