Abstract:In this paper, a poly ligand exchanger, Cu(II)-loaded chelating resin bearing the functional group of weak iminodiacetate acid was prepared to efficiently remove ammonia from solutions. Batch adsorption equilibrium experiments were conducted under a range of conditions to determine the optimum adsorption conditions. The effects of contact time, pH, resin dosage and temperature on the removal of ammonia by a Cu(II)-loaded resin were determined. The maximum removal efficiency was reached at pH 9.5 at room temperature, 25°C, in 300 min. The maximum ammonia adsorption capacity was found to be 45.66 mg/L. The maximum adsorption capacities decreased with the increasing of solution temperature. Langmuir, Freundlich and Temkin isotherm models were used for fitting the adsorption experimental data without competing ions and the Langmuir isotherm model was proved to be the best-fitting model by comparing the corresponding correlation coefficients (R2) of the listed models. The effect of competing ions Na+ and Ca2+ on the adsorption of the Cu(II)-loaded resin for ammonia was investigated. The results showed that the existing of competing ions had a negative effect on the ammonia removal. The adsorption capacities decreased with the increasing concentration of competing ions. The Langmuir isotherm model was used to fit the experimental data and proved efficient. The existing of competing ions in solutions was unfavorable for ammonia adsorption and the weakening effect of bivalent Ca2+ was stronger than the monovalent Na+. The ammonia adsorption capacity was relatively high compared with other ammonia adsorbents and the Cu(II)-loaded resin was an economically feasible and promising technology for ammonia removal.

Adsorption property and mechanism of 201×7 strongly basic anion exchange resin for cyanide

Recovery of Cyanide with 201×7 Strongly Basic Anion Exchange Resin

Adsorption of D261 Macroporous Resin for Cyanide

Study on the adsorption properties and principles of D261 macroporous resin for cyanide

High Efficient Removal of Cu(II) by a Chelating Resin from Strong Acidic Solutions: Complex Formation and DFT Certification

The progress of cyanide wastewater treatment with ion-exchange resins

ADSORPTION OF ION EXCHANGE RESIN FOR COPPER ION IN ORGANIC WASTE WATER

Reagent Elution Combined with Positive Pressure Filtration: A Zero-Discharge Method for Cyanide Tailings Remediation

Adsorption of divalent heavy metal ions onto IDA-chelating resins: simulation of physicochemical structures and elucidation of interaction mechanisms.

Adsorption Performances for Aqueous Cu(II) onto Chelating Resin Dowex M-4195: Interaction Mechanism Investigation

Selective removal of nitrate from water by a macroporous strong basic anion exchange resin

Efficiency and mechanism of amidoxime-modified X-type zeolite (AO-XZ) for Cs+ adsorption

A novel poly ligand exchanger – Cu(II)-loaded chelating resin for the removal of ammonia-nitrogen in aqueous solutions

Effective Adsorption Ag(I) Onto Triethylenetetramine-Modified Chitosan Beads: Adsorption Equilibrium, Kinetic, and Thermodynamic Studies

Adsorption Mechanisms of Heavy Metal Ions from Drinking Water by Weakly Basic Anion Exchange Resins

Adsorption of Rhenium(VII) with Anion Exchange Resin D318

The adsorption and desorption behavior and mechanism research of cobalt, nickel and copper in nitrite - sulfuric acid system

Performance and mechanism of selective adsorption of silver to L-cysteine functionalized cellulose microsphere

Adsorption of Nitrate by a Novel Polyacrylic Anion Exchange Resin from Water with Dissolved Organic Matters: Batch and Column Study

SEPARATION OF Cu(Ⅱ) AND Ni(Ⅱ) FROM AQUEOUS MEDIA BY PYRIDINE CHELATING RESIN

SELECTION OF ION EXCHANGE RESINS AND RECYCLE OF CITRIC SOLUTION