Abstract:Under extreme earthquakes, a continuous bridge tends to fail because of the damage to the bearing or the pier. A strong connection between the girder and the pier decreases the bearing displacement, but the increased inertia force of the girder to the base of the pier leads to pier damage. Conversely, a weak connection while protecting the pier causes bearing damage. In many cases, the bridge loses its function due to the damages concentrated on local members, while the rest of the members remain undamaged. To simultaneously protect both the bearing and pier during earthquakes with an evenly distributed damage pattern, a new real-time semi-active control algorithm based on the damage of bridge members (RTSD) using magneto-rheological (MR) dampers is proposed. Two displacement indices are established to represent the damage status of the bearing and pier and are used as control signals for the MR damper forces. A typical three-span continuous reinforced concrete bridge modeled by nonlinear fiber damage elements is used for the demonstration of the proposed method. Passive controls using viscous dampers (PVD) and MR dampers with a constant current (PMR) are also adopted for comparisons. Numerical simulation results show that the proposed method is more effective in protecting the bearing and pier than the passive controls. With the RTSD control, the damages to the bearing and pier are balanced and the limited damages to each pier can be evenly developed within the allowable range. Moreover, the initial damper force can be set in a wide range for the RTSD control to protect both the bearing and pier under various earthquakes. In contrast, it is impossible to select a proper damper force by passive controls. The RTSD control can also control the pier damage within different prescribed targets under extreme earthquakes.

Research on Pseudo-dynamic Test Control of Single Continuous Bridge under Multi-support Seismic Excitation

State of structural seismic response under multi-support excitations and suggestions on spatial structures

Study on remote collaborative pseudo-dynamic tests of multi-story frames

NETWORKED STRUCTURAL LABORATORIES:DEVELOPMENT AND APPLICATION OF REMOTE PSEUDO-DYNAMIC TESTING PLATFORMS FOR BRIDGE STRUCTURES

Development of a Remotely Collaborative Pseudo-dynamic Testing Platform for Bridge Structures

Remote Collaborative Pseudo-dynamic Tests of a Ten-story Concrete Filled Steel Tubular Composite Frame

Remote Hybrid Testing of Asymmetric Structures under Earthquake Excitation

Remotely Collaborative Pseudo-Dynamic Testing Of A Multi-Span Bridge

Dynamic Characteristics and Multi-support Seismic Response Analysis of a Super-large-span Suspension Bridge

Stochastic Seismic Response Analysis of Long-span Continuous Rigid Frame Bridge

Seismic Analysis of Long Span Continuous Rigid-Frame Bridge with Thin-Walled High Piers

Research on Frame Structural Pseudo-dynamic Test Method

Study on Semi-Active Control of Highway Bridge Pounding under Seismic Excitations

Nonlinear seismic response and damage analysis for continuous prestressed concrete rigid-frame bridge considering internal force state under near-fault ground motions

Pseudo-Dynamic Sub-Structural Test for Circular Steel Bridge Pier with Partially Concrete-Filled

Study and Development on Shake Table Tests of Scaled Models of Bridge Engineering

Modeling and Control of the CSCEC Multi-Function Testing System

Shaking Table Test on Seismic Performance of Continuous Rigid Frame Bridge with Cast-in-place and Fabricated Super High Piers

Application of Spatial Lateral Constrained Loading Feedback Control Method in Pseudo-Static Testing

Seismic damage control of nonlinear continuous reinforced concrete bridges under extreme earthquakes using MR dampers

Research on Longitudinal Collapse Mode and Control of the Continuous Bridge under Strong Seismic Excitations