Abstract:At present, many modification methods have been proposed to improve the performance of recycled aggregate concrete (RAC). In this study, tests on the compressive strength and damping properties of modified RAC with the addition of different proportions of recycled coarse aggregate (RCA) (0, 50, 100%), rubber powder (10, 15, 20%), steel fibre (5, 7.5, 10%) and fly ash (15, 20, 5%) are carried out. To elucidate the effect of the modification method on the interfacial transition zone (ITZ) performance of RAC, model ITZ specimens are used for push-out tests. The results show that when the replacement rate of RCA reaches 100%, the loss factor of the RAC is 6.0% higher than that of natural aggregate concrete; however, the compressive strength of the RAC decreases by 22.6%. With the addition of 20% rubber powder, the damping capacity of the modified RAC increases by 213.7%, while the compressive strength of the modified RAC decreases by 47.5%. However, with the addition of steel fibre and fly ash, both the compressive strength and loss factor of the RAC specimens increase. With a steel fibre content of 10 wt%, the compressive strength and loss factor of the RAC increase by 21.9% and 15.2%, respectively. With a fly ash content of 25 wt%, the compressive strength and loss factor of the RAC increase by 8.6% and 6.9%, respectively. This demonstrates that steel fibre and fly ash are effective in improving both the damping properties and compressive strength of RAC, and steel fibre is more effective than fly ash. Two methods were used for modification of the RAC: reinforcing the RCA through impregnation with a 0.5% polyvinyl alcohol (PVA) emulsion and nano-SiO 2 solution, and strengthening the RAC integrally through the addition of fly ash as an admixture. Both of these techniques can improve the ITZ bond strength between the RAC and new mortar. Replacing 10% of the cement with fly ash in the new mortar is shown to be the best method to improve the ITZ strength.

TEST ON C50 RECYCLED AGGREGATE CONCRETE(RAC)

Development of Sustainable Self-Compacting Concrete Using Recycled Concrete Aggregate and Fly Ash, Slag, Silica Fume

Intensified Test Research on the Influence of Polypropylene Fiber & Silica Fume on Recycled Concrete

Influence of Construction Conditions on Properties of Recycled Concrete

Performance of Recycled Aggregate Concrete in A Real Project

Properties of Recycled Aggregate Concrete with Different Water Control Methods

Optimal Utilization of Low-Quality Construction Waste and Industrial Byproducts in Sustainable Recycled Concrete

Steel Corrosion and Corrosion-Induced Cracking in Reinforced Concrete with Carbonated Recycled Aggregate

High-strain Rate Compressive Behavior of Concrete Made with Substituted Coarse Aggregates: Recycled Crushed Concrete and Clay Bricks

Experimental study on the compressive strength, damping and interfacial transition zone properties of modified recycled aggregate concrete

Study on Preparation of High Early Strength Recycled Aggregate Concrete

Mixture Design and Mechanical Properties of Recycled Mortar and Fully Recycled Aggregate Concrete Incorporated with Fly Ash

Testing and Prediction of the Strength Development of Recycled-Aggregate Concrete with Large Particle Natural Aggregate

Mechanical properties of recycled concrete with demolished waste concrete aggregate and clay brick aggregate

Research on Self-Compacting Concrete Made with Recycled Aggregate

Synergetic Effect of Fly Ash and Ground-Granulated Blast Slag on Improving the Chloride Permeability and Freeze–thaw Resistance of Recycled Aggregate Concrete

Study on Mechanical and Shrinkage Properties of High Belite Sulphoaluminate Cement-Based Green Recycled Aggregate Concrete

Mechanical Properties and ITZ Microstructure of Recycled Aggregate Concrete Using Carbonated Recycled Coarse Aggregate

Review of the Strengthening Methods and Mechanical Properties of Recycled Aggregate Concrete (RAC)

Optimization of the preparation process of Fair-Faced concrete incorporating recycled aggregates