Application of Three-dimension Image Manipulation Techniques in Kyphosis Reshaping Design

袁宁,田伟,刘波,李勤,张桂林,胡临,李志宇,袁强,张波
DOI: https://doi.org/10.3969/j.issn.1674-4659.2010.07.032
2010-01-01
Abstract:Objective The preoperation image data of kyphosis patients were analysed by 3-dimension image manipulation software. Preoperation design and surgery simulation were done to spine reshaping. Methods Radiology image data of kyphosis patients from April,2004 to July,2006 were got and analysed by 3-dimension manipulation software.The series CT scan data were 3-dimensional reconstructed. The Cobb angle through median sagittal plan,the cobb angle through bilateral pedicle of vertebral arch,bilateral reshaping angle through pedicle of vertebral arch and transverse diameter of adjacent pedicle of vertebral arch were measured on sagittal reconstruction plan. Using these data kyphosis reshaping plan was designed and simulated. Results Thirty patients of kyphosis were enrolled and including eight pa-tients of thoracic vertebral kyphosis and twenty two patients of lumbar vertebral kyphosis. There were twenty four patients of old fracture,three patients of tuberculosis,one patient of hemivertebrae,one case of undetermined. The ages were from eighty to sixty six. The symptoms of back pain and neural dysfunction of all the patients improved significantly after operation. Preoperational Cobb angles of the kyphosis vertebrae were 10° ~ 60°,average angle 26.4°. Postoperational Cobb angles are 0°~35°,average angle 14.7°. Direct-viewing of kyphosis vertebrae could be got by 3-dimension manipulation software and could help preoperation design of kyphosis patients surgery. Conclusions Sufficient information of diseased region can be got through spiral CT scanning. With the development of computer techniques,the calculation speed becomes more and more rapid. With 3-dimension reconstruction,sagittal plan and coronal plan and 3-dimensional image can be got,which can make kyphosis reshaping preoperaion design more accurate and direct-viewing,and can help the perform of operative reshaping plan.
What problem does this paper attempt to address?