Abstract:A key role in HSM (High Speed Machining) is played by the NC program code, which guides the tool along a programmed path without jumps in velocity and acceleration. The commonly used CAM (Computer Aided Manufacturing) software offers many operations for dynamic machining, but the generated code is difficult to edit. An alternative is to use parameterized technology cycles. Unfortunately, the circular pocket cycle available on the Siemens Sinumerik 840D controller was not designed for HSM machining. The purpose of the article is to program an Archimedes' spiral using modified tool radius compensation. The parametric NC code was implemented on the Siemens Sinumerik 840D controller as a technology cycle. The obtained trajectory of the tool meets the curvature continuity condition (C 2 continuity). The algorithm uses 3 NC program blocks to define the spiral, regardless of its length. Tool positions are calculated directly by the interpolator during the tool's circular motion (G2/G3). Spiral step is achieved by an additional contour offset (OFFN function), and also by multiple repetitions of circles (TURN function). The change in the effective tool radius value during active tool radius compensation (G41/G42) moves the tool away from the contour along the length of the entire NC block. Several spiral programming variants that are used in cycles were analyzed to identify the feed rate drops at joining points between program blocks. During the process, the trajectory and feed rate were recorded using the Sinumerik Trace function. A problem with the Siemens Sinumerik controller was identified when machine axes exceed the acceleration limit. Synchronized actions were implemented to reduce the feed rate, with the acceleration and jerk limit that are specified in the part program being taken into account. The presented cycle, with the graphical user interface, highlights the potential for HSM milling. The conducted experiment shows the need to supplement the Siemens Sinumerik controller with Archimedes' spiral interpolation. New technology cycles will increase productivity and open up new possibilities, such as tapered threads milling.

Research on Numerical Control Machining Method of Helicoid

Research on the key technique for numerical control grinding arbitrary n-polygon shafts

A Novel Helical Milling End-Effector and Its Application

Design Method and Numerical Control Machining Principle for an Arbitrary N-Polygon Noncircular Section

Geometric characteristics analysis and parametric modeling for screw rotor precision machining

Research on CAM of Generating Manufacturing Spiral Bevel Gear Based on Machining Center

An efficient five-axis machining method of centrifugal impeller based on regional milling

Judging of Machining Feasibility and Calculation of Midsection for the Five-Axis Milling of Shrouded Centrifugal Impeller

Key Technologies Research For Impellers Machining Based On Nx

STUDY ON THE KINEMATICS OF NC MACHINING FOR THE HELICOID WITH SPECIAL SHAPE AND ITS APPLICATION

Numerical Control Tool-Path Generation for Subdivision Surface Using Toroidal Cutter on 5-Axis Machine Tool

Intelligent NC Machining Programme Software for Rotative Part

Research on the Simulation of NC Milling Program Based on VERICUT Oriented to the Five-Axis Micro-Milling System

Development of a Numerical Control Rotor Straightening Machine

Milling path planning for helical surface copper electrodes

Research on design and cutting performance of revolving lemniscate milling cutter

Analysis of Four Axis Linkage Numerical Control Processing Programming of Impeller Based on UG

Modeling and machining of integral impeller based on NURBS curve

Modified tool radius compensation in the Archimedes' spiral tool path for high speed machining of circular geometry

A Method of Generating Spiral Tool Path for Direct Three-Axis Computer Numerical Control Machining of Measured Cloud of Point

Computer-integrated shaving processing for spiroid face gear on a five-axis CNC machine