Study on Catalytic Performance and Attrition Strength of the Ruhrchemie Catalyst for the Fischer-Tropsch Synthesis in A Stirred Tank Slurry Reactor

WP Ma,YJ Ding,VHC Vazquez,DB Bukur
DOI: https://doi.org/10.1016/j.apcata.2004.03.024
2004-01-01
Abstract:Activity and selectivity of H2, CO, syngas pretreated and non-pretreated Ruhrchemie catalyst (100 Fe/5 Cu/4.2 K/25 SiO2 on mass basis) used for the Fischer–Tropsch synthesis (FTS) were studied in a stirred tank slurry reactor (STSR). Catalyst activity was the highest after the CO and H2 pretreatments, whereas the non-pretreated catalyst was the least active. Methane selectivities on the CO, syngas reduced and unreduced catalysts were similar (3.9–4.3wt.%), and lower than that on the H2 reduced catalyst (5.3%). Liquid plus wax (C5+ hydrocarbons) selectivity was high in all four tests (∼80%). The H2 reduced catalyst produced less olefins and had the highest 2-olefin selectivity, whereas the non-pretreated and CO pretreated catalysts had the highest olefin content and the lowest 2-olefin selectivity. Attrition strength of the Ruhrchemie catalyst after 429h of FTS was found to be adequate under severe hydrodynamic conditions encountered in the STSR. Reduction in the volume moment diameter was 14.3%, whereas, increase in fraction of particles smaller than 10μm was only 2.6%.
What problem does this paper attempt to address?