Abstract:The carbon dots doped with chlorine and phosphorus (CDs-Cl,P) were used as chemiluminescence (CL) reagent for the sensitive detection of copper ions (Cu2+) and tannin (TA). The CDs-Cl,P was found to strongly enhance the reaction of H2O2 and KMnO4 in alkaline medium. The enhanced CL behavior of CDs-Cl,P was investigated and it was found that some radicals such as •OH, •O2- and 1O2 appeared in the CL reaction process. The participation of Cu2+ could result in an enhanced CL intensity of the CDs-Cl,P-H2O2-KMnO4 system due to the Cu2+-catalyzed decomposition of H2O2 resulting in more •OH generation. Therefore, the CDs-Cl,P-H2O2-KMnO4 system was used to selectively quantify Cu2+ in solution by CL emission. A linear increase was observed between CL intensity and Cu2+ concentration. The CDs-Cl,P-H2O2-KMnO4 system allowed the detection of Cu2+ down to lower concentration of 0.1 μM with a linear range of 0.2-60.0 μM. Moreover, TA as a common polyphenolic compound, could selectively decrease the CL signal of the CDs-Cl,P-H2O2-KMnO4-Cu2+ system due to its complexation with Cu2+. On this basis, the CL assay for TA was also developed. The detection limit was 0.14 μM and the linear range was from 5.0 μM to 100.0 μM. The proposed method was successfully applied to the determination of Cu2+ and TA in water, rice dumplings leaves, sodium copper chlorophyllin and wine samples with satisfactory results.

Flow injection chemiluminescent detection of trace Co(II) with dibromoalizarin violet-H 2 O 2 -CTMAB system

Flowerlike Co-Mofs Catalyzed Chemiluminescence for Sensitive Detection of Tetrachlorophenquinone in Environmental Waters

A method of high sensitivity and in situ determination of trace cobalt(II) in water samples with salicyl fluorone.

Chemiluminescence Detection of 10-16 mol/L Level Co( II ) with Field-amplified Sample Injection in Capillary Electrophoresis

Ag and N-doped carbon dots-enhanced H2O2-Co2+ chemiluminescence and its application for the determination of Co2+ and hydroquinone

Determination of Trace Amounts of Chromium (vi) by Flow Injection Analysis with Chemiluminescence Detection

Continuous Flow Analysis Combined with a Light-Absorption Ratio Variation Approach for Determination of Copper at ng/ml Level in Natural Water

Ultrasensitive chemiluminescence detection of sub-fM level Co(II) in capillary electrophoresis

Development of A Luminol-Based Chemiluminescence Flow-Injection Method for the Determination of Dichlorvos Pesticide

Chemiluminescence Determination of Chromium(iii) and Total Chromium in Water Samples Using the Periodate-Lucigenin Reaction

A Novel Method for Co(Ii) and Cu(Ii) Analysis by Capillary Electrophoresis with Chemiluminescence Detection

Luminol Chemiluminescence in Unbuffered Solutions with a Cobalt(ii)-Ethanolamine Complex Immobilized on Resin As Catalyst and Its Application to Analysis.

Chemiluminescence from fluorescent organic compounds induced by cobalt(II) catalyzed decomposition of peroxomonosulfate

Simultaneous Determination of Copper(II) and Cobalt(II) by Ion Chromatography Coupled with Chemiluminescent Detection

Liquid-Phase Cyclic Chemiluminescence for the Identification of Cobalt Speciation.

Chemiluminescence flow injection analysis of 1,3-dichloro-5,5-dimethylhydantoin in swimming pool water.

Determination of Ultra-Trace Cobalt in Water Samples Using Dispersive Liquid-Liquid Microextraction Followed by Graphite Furnace Atomic Absorption Spectrometry

Chemiluminescence Signal Amplification for Determination of Tetrachlorobenzoquinone Based on Acidified Tungsten Disulfide Quantum Dots

Flow-injection Investigation of the Chemiluminescent Reaction of Bis(2,4,6-(Trichlorophenyl)oxalate) with Free Chlorine

Flow injection determination of cationic surfactants by using N-bromosuccinimide and N-chlorosuccinimide as new oxidizing agents for luminol chemiluminescence

Chemiluminescence of doped carbon dots with H2O2-KMnO4 system for the detection of Cu2+ and tannin