Abstract:This study focuses on applying intelligent modeling methods to different injection molding process parameters, to analyze the influence of temperature distribution and warpage on the actual development of auto locks. It explores the auto locks using computer-aided engineering (CAE) simulation performance analysis and the optimization of process parameters by combining multiple quality characteristics (warpage and average temperature). In this experimental design, combinations were explored for each single objective optimization process parameter, using the Taguchi robust design process, with the L18 (21 × 37) orthogonal table. The control factors were injection time, material temperature, mold temperature, injection pressure, packing pressure, packing time, cooling liquid, and cooling temperature. The warpage and temperature distribution were analysed as performance indices. Then, signal-to-noise ratios (S/N ratios) were calculated. Gray correlation analysis, with normalization of the S/N ratio, was used to obtain the gray correlation coefficient, which was substituted into the fuzzy theory to obtain the multiple performance characteristic index. The maximum multiple performance characteristic index was used to find multiple quality characteristic-optimized process parameters. The optimal injection molding process parameters with single objective are a warpage of 0.783 mm and an average temperature of 235.23 °C. The optimal parameters with multi-objective are a warpage of 0.753 mm and an average temperature of 238.71 °C. The optimal parameters were then used to explore the different cooling designs (original cooling, square cooling, and conformal cooling), considering the effect of the plastics temperature distribution and warpage. The results showed that, based on the design of the different cooling systems, conformal cooling obtained an optimal warpage of 0.661 mm and a temperature of 237.62 °C. Furthermore, the conformal cooling system is smaller than the original cooling system; it reduces the warpage by 12.2%, and the average temperature by 0.46%.

Analysis and Optimization on Injection Insert Molding Processing

Sequential Optimization Design Research on Rear Mould Board of Injection Machine

Topological and Parameter Optimization Design on Front Platen of Injection Molding Machine

Structure optimization by using CAE for the automobile inj ection part with steel insert

CAE Optimization Analysis of Injection Process Parameters for the Moulding of Air Conditioner Bracket

CAE-based Injection Process Analysis and Optimization Design of Mobile Phone Housing

Simulation and Optimization on the Injection Molding for Auto-Bumper

Research on Lightweight Injection Molding (CAE) and Numerical Simulation Calculate of New Energy Vehicle

Warpage analysis and optimization of thin-walled injection molding parts based on numerical simulation and orthogonal experiment

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

Injection Molding Optimization for Minimizing the Defects of Weld Lines

Study of injection molding process simulation and mold design of automotive back door panel

Mold design and forming process parameters optimization for passenger vehicle front wing plate

Application of Intelligent Modeling Method to Optimize the Multiple Quality Characteristics of the Injection Molding Process of Automobile Lock Parts

3D Modeling in Injection Molding Seat and Optimization of Its Process Parameters

Optimization of Injection Mold Based on Fuzzy Moldability Evaluation

Optimization of injection molding process parameters to improve the mechanical performance of polymer product against impact

Optimization of Injection Molding Processing Parameters of Display Shell Based the Orthogonal Experiment

Multi-Objective Optimization of Injection Molding Parameters for Manufacturing Thin-Walled Composite Connector Terminals

A method combining optimization algorithm and inverse-deformation design for improving the injection quality of box-shaped parts

Design of Cooling System for Narrow Area of Automotive Injection Mold Based on Computer Technology