Abstract:Unraveling the microstructural heterogeneity is an important issue to understand the physical and mechanical properties of metallic glasses. Structural relaxation below the glass transition temperature Tg and cold rolling at ambient temperature are effective ways to tune the state within the potential energy landscape of metallic glasses, modifying the microstructural heterogeneity. With the help of nanoindentation technique, by scrutinizing the local reduced modulus and hardness of a typical Zr50Cu40Al10 metallic glasses in different energy states (from structural relaxed state to rejuvenated state), we demonstrate that the enhancement of microstructural heterogeneity plays an important role in tailoring the mechanical behavior. The internal friction coefficient is obtained by fitting the experimental load-displacement curves with finite element simulation. It is found that internal friction coefficient decreases with the increase of concentration of flow defects. The stress exponent obtained from the creep stage shows a strong dependence on the structural state of metallic glasses. Effects of structural relaxation and rejuvenation on the structural state are rationalized in terms of the relative flow defects concentration. Finally, the statistics of discrete displacement bursts during the deformation process were probed. We find that the displacement bursts behavior is sensitive to the structural energy state (microstructural heterogeneity). The displacement bursts phenomenon changes from obvious (relaxed state) to unapparent behaviors (rejuvenated state). By given a physical schematic, the correlation between the displacement bursts size and the shear band size in the local plastic zones is well established, which will lead to a deeper understanding of the rejuvenation-induced plasticity of metallic glasses.

Characterization of plastic flow in two Zr-based bulk metallic glasses

The Characterization of Plastic Flow in Three Different Bulk Metallic Glass Systems

Plastic Deformation of Zr-based Bulk Metallic Glasses under Nanoindentation

Deformation Morphology Underneath the Vickers Indent in Bulk Metallic Glasses

CHARACTERIZATION OF SHEAR BANDS IN TWO BULK METALLIC GLASSES WITH DIFFERENT INHERENT PLASTICITY

The Characterization of Plastic Deformation in Ce-Based Bulk Metallic Glasses

Mechanical Behavior of Zr65Al10Ni10Cu15 and Zr52.5Al10Ni10Cu15Be12.5 Bulk Metallic Glasses

Instrumented indentation study of plastic deformation in bulk metallic glasses

Mechanical Behavior of Zr 65 Al 10 Ni 10 Cu 15 and Zr 52 : 5 Al 10 Ni 10 Cu 15 Be 12 : 5 Bulk Metallic Glasses

Effect of Pre-Existing Shear Bands on Mechanical Properties and Serration Behaviors in Bulk Metallic Glasses

High temperature deformation behaviors of the Zr 63.36 Cu 14.52 Ni 10.12 Al 12 bulk metallic glass

Rate-dependent Plastic Deformation of TiZrHfCuNiBe High Entropy Bulk Metallic Glass

A Series of Zr-Based Bulk Metallic Glasses with Room Temperature Plasticity

Structural Heterogeneity Originated Plasticity in Zr–Cu–Al Bulk Metallic Glasses

Relating melting temperature with structure heterogeneity and plasticity of Zr57Cu20Al10Ni8Ag5 bulk metallic glass

Effect of the cooling rate on plastic deformability of a Zr-based bulk metallic glass

The Introduction of Highly Dense Shear Bands and Their Effect on Plastic Deformation in Zr and Cu-based Bulk Metallic Glasses

Unraveling the microstructural heterogeneity and plasticity of Zr<sub>50</sub>Cu<sub>40</sub>Al<sub>10</sub> bulk metallic glass by nanoindentation

Enhanced Plasticity in Zr–Cu–Ag–Al–Be Bulk Metallic Glasses

Plastic Deformation Behaviors of Ni- and Zr-based Bulk Metallic Glasses Subjected to Nanoindentation

Mechanical Properties for a Series of Zr-based Bulk Metallic Glasses