Effect of Mo Content on the Microstructure and Stress Rupture of A Ni Base Single Crystal Superalloy

Ma Wenyou,Han Yafang,Li Shusuo,Zheng Yunrong,Gong Shengkai
DOI: https://doi.org/10.3321/j.issn:0412-1961.2006.11.014
IF: 1.797
2006-01-01
ACTA METALLURGICA SINICA
Abstract:Ni base single crystal superalloys of three kinds of Mo content were prepared by screw selecting method. The microstructures and stress rupture properties of the superalloys with 2%, 3% and 4% Mo were compared. The results showed that as-cast structures of the three alloys were composed of gamma and gamma' phases. After heat treatment, mu phase obviously precipitated and grew in the alloys with 4% Mo, while only a few p phase in the alloys with 3% Mo, and in 2% Mo containing alloy no mu phase precipitated after heat exposure to 1100 degrees C /500 h. The mu phase was mainly composed of Mo, Re, W, Cr, Co, Nb etc., in which for the tendency of forming mu phase Mo is the strongest, Re, W, Cr are the second place and Co, Nb are the weakest. A lot of precipitation of rod-like mu phases damaged high temperature stress rupture properties of alloys. Due to a few mu phase no effect on the stress rupture property and the solid solution strengthening of Mo, the optimum Mo content should be 3% for the based alloy Ni-5Cr-10Co-4W-3Re-5.6Al-8Ta-1Ti-0.5Nb.
What problem does this paper attempt to address?