Abstract:Abstract The aim of the research work was to investigate the effect of superficial gas velocity and solids concentration on the critical agitator speed, gas hold-up and averaged residence time of gas bubbles in an agitated gas-solid-liquid system. Experimental studies were conducted in a vessel of the inner diameter of 0.634 m. Different high-speed impellers: Rushton and Smith turbines, A 315 and HE 3 impellers, were used for agitation. The measurements were conducted in systems with different physical parameters of the continuous phase. Liquid phases were: distilled water (coalescing system) or aqueous solutions of NaCl (non-coalescing systems). The experiments were carried out at five different values of solids concentration and gas flow rate. Experimental analysis of the conditions of gas bubbles dispersion and particles suspension in the vessel with a flat bottom and four standard baffles showed that both gas and solid phases strongly affected the critical agitation speed necessary to produce a three-phase system. On the basis of experimental studies, the critical agitator speed for all agitators working in the gas-solid-liquid systems was found. An increase of superficial gas velocity caused a significant increase of the gas hold-up in both coalescing and non-coalescing three-phase systems. The type of the impeller strongly affected the parameters considered in this work. Low values of the critical impeller speed together with the relatively short average gas bubbles residence time tR in three phase systems were characteristic for the A 315 impeller. Radial flow Rushton and Smith turbines are high-energy consuming impellers but they enable to maintain longer gas bubbles residence time and to obtain higher values of the gas hold-up in the three-phase systems. Empirical correlations were proposed for the critical agitator speed, mean specific energy dissipated and the gas hold-up prediction. Its parameters were fitted using experimental data.

Critical impeller speed for suspending solids in aerated agitation tanks

Study on Local Gas-Liquid Dispersion in Dual-Impeller Aerated Stirred Vessel

Measurement of Critical Suspension Speed in Stirred Tank Using Acoustic Emission Technique Based on Hilbert-Huang Transform

Critical Agitating Speed for Particle Suspension by Multideck Impeller under Aerating Conditions

Effect of Agitation on the Fluidization Behavior of a Gas–solid Fluidized Bed with a Frame Impeller

Numerical Study on Solid Suspension Characteristics of a Coaxial Mixer in Viscous Systems

Critical speed of gas- liquid- settling particle three- phase system in agitated vessels

Experimental Investigation on Solid Particle Distribution in Dense Solid–liquid Stirred Tank

GAS DISPERSION AND SOLID SUSPENSION IN A THREE-PHASE STIRRED TANK WITH MULTIPLE IMPELLERS

Suspension of Buoyant Particles in a Three Phase Stirred Tank

The effect of impeller pumping and fluid rheology on solids suspension in a stirred vessel

Critical speed for suspension of gas-liquid-floating particle

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

Numerical investigation on the intensification of coaxial slurry mixing systems

Measurement of critical dispersion speed in stirred tank based on Hilbert-Huang transform

Solid suspension and gas dispersion in gas-solid-liquid agitated systems

Progress on critical suspension speed of gas-liquid-particle three-phase system

Critical Impeller Speeds for a Gas-Inducing Stirring Tank Loaded with Solid Particles

Solids Suspension Study in a Side-Entering Stirred Tank Through CFD Modeling

Suspension of high concentration solids in a pilot scale jet-flow high shear mixer

Effects of Equipment and Process Variables on the Suspension of Buoyant Particles in Gas-Sparged Vessels