Abstract:This study proposes a comprehensive study on liquid silicone rubber (LSR) formulations to unravel which components (among functional polydimethylsiloxane polymers and modified silica fillers) improve the mechanical properties of the final materials. In this first part, various industrial products have been deformulated using conventional chemical analyses. The silica content and their surface chemistry were assessed by TGA. Architecture and molar mass of polymers were deduced from (29)Si NMR and SEC in toluene, respectively. Relative concentrations of hydride and vinyl reactive groups and stoichiometric imbalance (r = nSiH/nSiVi) were quantified by proton NMR. Stoichiometric imbalance is slightly higher than 1.5 for cross-linker with hydride functions well redistributed along the chain, whereas for some formulations, r's as high as 3.7 were implemented. These variations has strong implications on the cross-linking density of the final material, since the remaining hydride groups react together and decrease the molar mass between cross-links. From the comparison between formulations, it was shown that hardness adjustment is mainly performed by playing on two parameters: filler content and molar mass between cross-linking points for hardness ranging from 20 to 30 Shore A. Above this limit, it is necessary to modify the silica surface with reactive groups, such as vinyl functions. Surprisingly, two formulations were shown to use a dual cross-linking catalysis systems, peroxide and platinum, leading to efficient and full cure even at lower temperature (typically 140 °C). Network topologies were estimated from the predicted chemistry of the materials in a final discussion part.

Investigation of Thermal Crosslinking and Pyrolysis of Ladderlike Silsesquioxanes in Vacuum by XRD Measurements and Weight Analysis

Synthesis and Characterization of Ladder-like Poly(vinylsilsesquioxanes)

Thermochemical process occurring in PLD-derived SiC films during vacuum annealing

Novel Diacetylinic Aryloxysilane Polymers: A New Thermally Cross-Linkable High Temperature Polymer System

Preparation and Property of Silane-crosslinked PVC

Polysiloxanes Polymers with Hyperbranched Structure and Multivinyl Functionality

Vapour Phase Grafting of Vinyltrimethoxysilane and Water Crosslinking of Polypropylene

Theoretical and experimental investigations into the pyrolysis mechanisms of silicon-modified phenolic resin under high temperatures

Synthesis and Characterization of Intercalated Ladder-Like Poly(vinylsilsesquioxanes)/organically Modified Montmorillonite Nanocomposites

Looking over liquid silicone rubbers: (1) network topology vs chemical formulations

Molecular Dynamics Simulation on the Heat Transfer in the Cross-Linked Poly(dimethylsiloxane).

Stretch-Induced Crystallization and Phase Transitions of Poly(dimethylsiloxane) at Low Temperatures: an in Situ Synchrotron Radiation Wide-Angle X-ray Scattering Study

Structural Evolution of Silica Gel and Silsesquioxane Using Thermal Curing.

Thermal and Crystallization Behavior of Silane‐crosslinked Polypropylene

Stretch-Induced Intermediate Structures and Crystallization of Poly(dimethylsiloxane): the Effect of Filler Content

Melt synthesis and characterization of poly(L-lactic acid) chain linked by multifunctional epoxy compound

Study on crosslinking of polymers and joining mechanism of SiC ceramic

DSC Analysis of Isothermal Melt-Crystallization, Glass Transition and Melting Behavior of Poly(l-Lactide) with Different Molecular Weights

A triphenylene-containing side chain liquid crystalline ladder-like polysiloxane and its highly ordered superstructure

Preparation, cure kinetics, and thermal properties of novel acetylene terminated silazanes

Preparation of liquid polycarbosilane containing vinyl ether group and its rapid curing through thiol‐ene click reaction