Abstract:At present, despite the great advances in polymer electrolyte membrane fuel cell (PEMFC) technology over the past two decades through intensive research and development activities, their large-scale commercialization is still hampered by their higher materials cost and lower reliability and durability. In this review, water management is given special consideration. Water management is of vital importance to achieve maximum performance and durability from PEMFCs. On the one hand, to maintain good proton conductivity, the relative humidity of inlet gases is typically held at a large value to ensure that the membrane remains fully hydrated. On the other hand, the pores of the catalyst layer (CL) and the gas diffusion layer (GDL) are frequently flooded by excessive liquid water, resulting in a higher mass transport resistance. Thus, a subtle equilibrium has to be maintained between membrane drying and liquid water flooding to prevent fuel cell degradation and guarantee a high performance level, which is the essential problem of water management. This paper presents a comprehensive review of the state-of-the-art studies of water management, including the experimental methods and modeling and simulation for the characterization of water management and the water management strategies. As one important aspect of water management, water flooding has been extensively studied during the last two decades. Herein, the causes, detection, effects on cell performance and mitigation strategies of water flooding are overviewed in detail. In the end of the paper the emphasis is given to: (i) the delicate equilibrium of membrane drying vs. water flooding in water management; (ii) determining which phenomenon is principally responsible for the deterioration of the PEMFC performance, the flooding of the porous electrode or the gas channels in the bipolar plate, and (iii) what measures should be taken to prevent water flooding from happening in PEMFCs.

Review on water content measurement technology for PEM fuel cell

Uniformity Identification and Sensitivity Analysis of Water Content of Each PEM Fuel Cell Based on New Online High Frequency Resistance Measurement Technique

A Review on Water Fault Diagnosis of a Proton Exchange Membrane Fuel Cell System

Review On Water Management Methods For Proton Exchange Membrane Fuel Cells

Water Content Estimation of PEM Fuel Cells Based on Exhaust Back Pressure

A Closed-Loop Water Management Methodology for PEM Fuel Cell System Based on Impedance Information Feedback

Water content diagnosis for proton exchange membrane fuel cell based on wavelet transformation

A Review Of Water Management In Polymer Electrolyte Membrane Fuel Cells

Investigation of Water and Heat Transfer Mechanism in PEMFCs Based on a Two-Phase Non-Isothermal Model

A review:In-situ segmented cell measuring local current density distribution for fuel cell

A Novel Water Content Sensor Design and Its Application for In-Situ Water Content Measurement Inside the Flow Channel of PEMFC

Experimental and Model Refinement of Water Content and Membrane Conductivity in Reinforced Composite Proton Exchange Membranes

A review on water balance in the membrane electrode assembly of proton exchange membrane fuel cells

Research Status of Water Management of Proton Exchange Membrane Fuel Cells

Numerical Modeling of Liquid Water Transport Inside and Across Membrane in PEM Fuel Cells

Water Content Estimation in Polymer Electrolyte Fuel Cells Simplified by Correlating Synchronous Electrochemical Impedance Spectroscopy and Neutron Imaging

Modeling Water and Thermal Transients Inside Proton Exchange Membrane for Vehicle Application Fuel Cells

Development of High Frequency Resistance Test Bench for High Power Fuel Cell Stack

In-Situ Measurement of Humidity Distribution and Its Effect on the Performance of a Proton Exchange Membrane Fuel Cell

Diagnosis of Water Failures in Proton Exchange Membrane Fuel Cell with Zero-Phase Ohmic Resistance and Fixed-Low-frequency Impedance

In-situ Measurement of Temperature and Humidity Distribution in Gas Channels for Commercial-Size Proton Exchange Membrane Fuel Cells