Abstract:Single-pixel imaging lidar is a novel technology that leverages single-pixel detectors without spatial resolution and spatial light modulators to capture images by reconstruction. This technique has potential imaging capability in non-visible wavelengths compared with surface array detectors. An avalanche photodiode (APD) is a device in which the internal photoelectric effect and the avalanche multiplication effect are exploited to detect and amplify optical signals. An encapsulated APD detector, with an APD device as the core, is the preferred photodetector for lidar due to its high quantum efficiency in the near-infrared waveband. However, research into APD detectors in China is still in the exploratory period, when most of the work focuses on theoretical analysis and experimental verification. This is a far cry from foreign research levels in key technologies, and the required near-infrared APD detectors with high sensitivity and low noise have to be imported at a high price. In this present study, an encapsulated APD detector was designed in a linear mode by integrating a bare APD tube, a bias power circuit, a temperature control circuit and a signal processing circuit, and the corresponding theoretical analysis, circuit design, circuit simulation and experimental tests were carried out. Then, the APD detector was applied in the single-pixel imaging lidar system. The study showed that the bias power circuit could provide the APD with an operating voltage of DC 1.6 V to 300 V and a ripple voltage of less than 4.2 mV. Not only that, the temperature control circuit quickly changed the operating state of the Thermo Electric Cooler (TEC) to stabilize the ambient temperature of the APD and maintain it at 25 ± 0.3 °C within 5 h. The signal processing circuit was designed with a multi-stage amplification cascade structure, effectively raising the gain of signal amplification. By comparison, the trial also suggested that the encapsulated APD detector and the commercial Licel detector had a good agreement on the scattered signal, such as a repetition rate and pulse width response under the same lidar environment. Therefore, target objects in real atmospheric environments could be imaged by applying the encapsulated APD detector to the near-infrared single-pixel imaging lidar system.

Application of Binary Character of Optoelectronic Devices in Lidar Based on Pulse Accumulation Method

Ranging Performance Model Considering the Pulse Pileup Effect for PMT-based Photon-Counting Lidars.

A depth measurement method using two structured light binary patterns

The Photon Detection Mode of Photomultiplier Tubes Considering the Pulse Height Distribution

A Binary Beam-Splitter For Lidar Beam-Shaping In Laser Imaging Application - Art. No. 66241j

Polarisation-modulated Photon-Counting 3D Imaging Based on a Negative Parabolic Pulse Model

Multi-Longitudinal-Mode High-Spectral-Resolution Lidar

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

Performance of Wide Dynamic Photomultiplier Applied in a Low Blind Zone Lidar

Long Range Detection of Line-Array Multi-Pulsed Coding Lidar by Combining the Accumulation Coherence and Subpixel-energy Detection Method

The Impact of Pulse Parameter on Modulated Lidar Performance

Integrated Encapsulation and Implementation of a Linear-Mode APD Detector for Single-Pixel Imaging Lidar

Spatial and Temporal Multiplexing Array Imaging Lidar Technique Based on OOCDMA

Spatially modulated scene illumination for intensity-compensated 2D array photon-counting LiDAR imaging

Analysis of Multiplex Laser Scanning Imagery Optical System

Modulated High Power and Narrow Pulse Width Laser Drive Circuit for Lidar System

SiPM-based LiDAR with multipulse sequence modulation and multithreshold signal processing

Optical OCDMA Coding and 3D Imaging Technique for Non-Scanning Full-Waveform LiDAR System.

Single-photon ranging lidar based on multi-repetition-rate pulse train correlation and accumulation

Pulse Accumulation Approach Based on Signal Phase Estimation for Doppler Wind Lidar

Pulse Saturation of APD Application Circuit and the Solution