Abstract:Since ytterbium (Yb) possesses a low work function of 2.6 eV and Yb fluoride generally has a high negative free energy of formation, it is conceivable to use Yb, either directly or parasitically, with a metal fluoride, as a cathode in organic light-emitting diodes (OLEDs). In this work, the electronic structure and chemistry at the interface of Yb/poly(9,9-dioctylfluorene-co-benzothiadiazole) (F8BT) were investigated by ultraviolet and x-ray photoemission spectroscopy (UPS and XPS, respectively). We found that the deposition of Yb on top of F8BT foremost formed organometallic complexes with the sulfur but interacted partly with the nitrogen of F8BT, and eventually formed a Yb–C complex at higher Yb coverages. In the UPS spectra, Yb deposition increased the relative peak intensities corresponding to the σ-bonds originated from the aliphatic side chains, implying that some of the π-conjugated carbons in the polymer backbone may be destroyed. These results agree well with the disappearance of the π-to-π* transition as observed from the shake-up peaks of the carbon 1s core level in the XPS. The chemistry at the interfaces of Yb/CsF/Au and Yb/CsF/F8BT was also examined by XPS. In both cases, Cs was liberated from the CsF upon Yb deposition and the Yb reacted with the liberated F to form YbF3. In the Yb/CsF/F8BT system, the dissociated Cs did not exist in the metallic state, but reacted with the N atoms and carbon backbone in the F8BT. The low work function of Cs (2.2 eV) may further enhance the injection of electrons into the polymer layer. More importantly, the utilization of Yb/CsF as an electrode is polymer independent, and the CsF layer between the Yb and F8BT could retard Yb diffusion into the bulk polymer. The present results are supported by a calculation of the free energy needed to liberate the Cs in the metal/CsF system using a simple thermodynamic model. It is suggested that the use of Yb/CsF cathode in the polymer offers an advantage over most other metal fluorides because the current electrode has a higher affinity to liberate Cs due to the high negative heat of formation of YbF3, although Yb alone may not be a good electron injector in OLEDs.

Electronic Structure of Yb2.75c60

X-Ray Photoemission Studies of Yb Intercalated C-60 Thin Film

Synchrotron Radiation Photoemission Study Of Yb-Intercalated C-60

Electronic Structure of Yb/H–Si (111) Interface

Electron Band-Structure Of C-60 Single-Crystal Using Synchrotron-Radiation

Structure and Raman behaviour of Sm2.75C60

Preparation and Photoemission Spectra of Rb3C60 Single-Crystal Thin Films

Study on Band Structure of YbB6 and Analysis of Its Optical Conductivity Spectrum

LUMO-derived Band Structure Ofk3c60

Synchrotron Radiation Photoemission Spectrum Study on K_3C_(60) Film

Role of Ytterbium and Ytterbium/Cesium Fluoride on the Chemistry of Poly(9,9-Dioctylfluorene-Co-Benzothiadiazole) As Investigated by Photoemission Spectroscopy

Synchrotron Radiation Angle-Resolved Photoemission Study of the Orientational Phase Transition for K3C60

Resolution of the discrepancy between the variation of the physical properties of Ce<sub>1-<i>x</i></sub>Yb<sub><i>x</i></sub>CoIn<sub>5</sub>single crystals and thin films with Yb composition

Yb Valence Change In Ce1-Xybxcoin5 From Spectroscopy And Bulk Properties

Structure and Properties of A Fulleride Sm6c60

Preparation of Rb3C60 Single Crystal Film and Stability of Rb3C60/C60 Interface

Resolution of the discrepancy between the variation of the physical properties of Ce1-xYbxCoIn5 single crystals and thin films with Yb composition

Electronic and optical properties of Yb-based 1-2-20 materials

Synthesis, crystal structure and properties of YB2C2

Geometry and Electronic Structure of Yb(III)[CH(SiMe3)2]3 from EPR and solid-state NMR augmented by Computations

Synthesis And Thermal Stability Of Binuclear Biscyclopentadienyl Lanthanide Thiolates, X-Ray Crystal Structure Of [(C5h5)(2)Yb(Mu-Sch2ch2ch2ch3)](2)