Abstract:This paper proposes an algorithm for robotic kinematic calibration based on a minimal product of exponentials (POE)-based model for the applications where only position measurements are required. Both joint zero-offset errors and initial frame twist error can be involved in this model. Analysis of the identifiability of these errors shows that at most six elements of these parameters can be identified. It also suggests that at least three noncollinear points on the end-effector should be measured to maximize the identifiability. Compared with the traditional POE-based model with full pose (position and orientation) measurements, the minimal model with only position measurements outperforms in terms of convenience, efficiency, and accuracy.Note to Practitioners-Kinematic calibration is pivotal to improve the position accuracy of a robot. To avoid the disadvantages of measuring the orientation of the end-effector during calibration, an algorithm using only position measurements is presented, with which one needs only position measurements of several points fixed on the end-effector without orientation information during the whole calibration process. This will greatly facilitate the scheme design as well as the practical operations. The identifiability of the parameters is then analyzed with two conclusions: 1) at most six elements of the joint zero-offsets and the initial frame twist in total can be identified simultaneously and 2) at least three points on the end-effector which are not collinear should be measured so as to make the identifiability maximum. According to these conclusions, one should carefully select parameters to formulate the error model and measure sufficient points on the end-effector during the calibration procedure.

A Screw Axis Identification Method For Serial Robot Calibration Based On The Poe Model

An Enhanced POE-Based Method with Identified Transmission Errors for Serial Robotic Kinematic Calibration.

An Improved Kinematic Model for Serial Robot Calibration Based on Local POE Formula Using Position Measurement

A Robot Calibration Method Based on Joint Angle Division and an Artificial Neural Network

Separable Nonlinear Least Squares Algorithm for Robust Kinematic Calibration of Serial Robots.

An Optimization Based Vision Calibration Method for PTZ Camera's Errors in Model and Execution

Kinematic Calibration for Articulated Arm Coordinate Measuring Machines Base on Particle Swarm Optimization

A Modeling and Calibration Method of Heavy-Duty Automated Fiber Placement Robot Considering Compliance and Joint-Dependent Errors

Inverse kinematics sub-problem solution algorithm for serial robot based on screw theory

Kinematic-Parameter Identification for Serial-Robot Calibration Based on POE Formula

POE-Based Robot Kinematic Calibration Using Axis Configuration Space and the Adjoint Error Model

A Minimal POE-Based Model for Robotic Kinematic Calibration with Only Position Measurements

Determination of the Identifiable Parameters in Robot Calibration Based on the POE Formula

Improved Inverse Kinematics Algorithm Using Screw Theory for a Six-DOF Robot Manipulator

A novel robot hand-eye calibration method to enhance calibration accuracy based on the POE model

A local POE-based self-calibration method using position and distance constraints for collaborative robots

Dynamic Modelling Using Screw Theory And Nonlinear Sliding Mode Control Of Serial Robot

A Vision-Based Fully-Automatic Calibration Method for Hand-Eye Serial Robot

Accurate Robot Calibration By Sai Method Through Visual Measurement

A minimal kinematic model for serial robot calibration using POE formula

Joint Calibration Method for Robot Measurement Systems