Abstract:Silicon -based ultra -thin flat heat pipes (UFHPs) that can be integrated with semiconductor devices provide an opportunity for electronic thermal management. To meet the requirements of various operation states, the impacts of gravity on the liquid plug characteristics and heat transfer performance of an UFHP are investigated by a visualization experiment conducted at different incline angles. Condensate flows back through microgrooves under the capillary pressure and gravity under a low heating power (capillary flow stage), and then excess condensate flows back along the edges of the UFHP under a higher heating power (gravitational flow stage). Over a certain heating power ( Q >= 14 W), liquid plug fluctuations caused by vapor entrainment are observed with periodic dry -out at the evaporator under large incline angles ( alpha >= 60 degrees ), corresponding to temperature fluctuations. Intense fluctuations of the liquid plug enhance sensible heat transfer, although the liquid plug occupies the condenser area and impedes the vapor flow. Meanwhile, evaporation at the evaporator benefits from corner -film evaporation until a large area of dry -out occurs. Due to the increased gravity and buoyancy, a larger incline angle is conducive to thermal performance enhancement, but this effect becomes restricted as the heating power rises. At a cooling -water temperature of 20 degrees C and an incline angle of 90 degrees , the lowest thermal resistances of the UFHP yield a value of 1.14 degrees C/W at 4 W in the steady stage and a value of 1.22 degrees C/W at 18 W in the fluctuation stage, respectively. The heat transfer limit of UFHP with overfilling reaches 24 W, compared with the theoretical heat transfer capacity of 8.9 W at an incline angle of 90 degrees . Additionally, a higher cooling -water temperature is beneficial for the thermal performance in the capillary flow stage, but not in the gravitational flow stage and fluctuation stage. This study provides guidance for the operational design of silicon -based UFHP for electronic thermal management.

Gravity Effects on the Performance of a Flat Loop Heat Pipe

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Liquid Plug Characteristics and Heat Transfer Performance of a Silicon-Based Ultra-Thin Flat Heat Pipe at Different Incline Angles

Investigation on the influence of the condenser length and its coupling effect with elevation on the performance of loop heat pipe

Experimental Study on Loop Heat Pipe with Flat Evaporator at Different Tilt Angles

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Experimental Study on Flat Loop Heat Pipes Used in HCPV Systems

Experimental Research on the Heat Performance of a Flat Copper-Water Loop Heat Pipe with Different Inventories

Visualization study of a flat confined loop heat pipe for electronic devices cooling

Experimental investigation of a loop heat pipe with a flat evaporator and cupric oxide nanofluids as working fluid

Experimental studies on a high performance compact loop heat pipe with a square flat evaporator

Visualized Investigation of Gas–liquid Stratified Flow Boiling of Water in a Natural Circulation Thermosyphon Loop with Horizontal Arranged Evaporator

Experimental investigation on the start-up performance of a loop heat pipe with three flat disk evaporators combined

Operating characteristics of a dual flat-evaporator loop heat pipe for single heat source cooling in any orientation

Heat Transfer Performance and Startup Characteristics of Separated Gravity Heat Pipe

Effect of Tilt Angle and Base Plate Design on the Performance of a Loop Heat Pipe Driven by Vapor–liquid Injector

Experimental Study on the Thermal Performance of Flat Loop Heat Pipe Applied in Data Center Cooling

Study of Gravity Effect on the Operating Characteristics of High-Temperature Bent Heat Pipes

Numerical investigation on transient and steady phase change heat transfer in the evaporator of a loop heat pipe

Experimental Study on the Flat Loop Heat Pipe with Minichannel Wick under Low Heat Flux

Effect of the working fluid transportation in the copper composite wick on the evaporation efficiency of a flat loop heat pipe