Abstract:Aiming at the fast protection requirements of electrical ships LVDC distribution system, this paper studies a topology of unidirectional vacuum hybrid circuit breaker. The hybrid circuit breaker is an improved current injection LVDC breaker based on precharged capacitor, which improves the dielectric recovery capability of vacuum interrupter after artificial current zero by using a freewheel diode. A synthetic test platform is built to study the dielectric strength recovery characteristics of a 45 mm diameter CuCr50 butt contact vacuum interrupter (driven by Thomson coil actuator, average opening speed of about 3 m/s)under high current(about 20 kA) and small gap(about 1 mm). The experimental results indicate that the dielectric strength of the contact can recover at a very fast speed within the arc time of 100 mu s; when the arc time is increased to 320 mu s, the dielectric strength of the contact cannot recover for a long time. Therefore, the design principle of the circuit breaker is obtained: within the arc time of 100 mu s, by increasing the arc time can increase the contact distance, so the transient interruption voltage tolerance margin of the circuit breaker can be improved. Based on the results of the test, this paper also proposes a calculation method of forced commutation circuit parameters, which is verified by the simulation. The research results show that the DC circuit breaker can realise the rapid breaking of 20 kA fault current within 2 ms, and has a good application prospect in the LVDC distribution system.

Design of Fast Protection Device for Current Limiter of Ship DC Distribution System

A Single-Ended Protection for Multi-terminal Flexible DC Distribution System

A Fast LVDC Vacuum Hybrid Circuit Breaker: Dielectric Recovery and Design Consideration

A Modified DC Fault Protection Scheme for Multi-Terminal HVDC Grid Based on Fault Current Limiters

A Fast Protection Scheme Using Fault Current Characteristics in Multi-terminal Flexible DC Distribution Network

Short Circuit Current Limiter in As Network

Fast Fault Protection Based on Direction of Fault Current for the High-Surety Power Supply System

Protection and Fault Isolation Scheme for DC Distribution Network Based on Active Current-Limiting Control

Analysis and Design of the High Current Rising Rate Hybrid DC Current Limiting Circuit Breaker

Design And Test Of Unified Power Flow Controller Protection Circuits

Single-ended DC line protection scheme based on first peak time of current-limiting reactor voltage

Design and Research of a Novel Unified Power Flow Controller with Fault Current Limiter

Control Strategy and Test Study of Bi-directional Current's Solid State Fault Current Limiter

A DC Solid-State Current Limiter With Adaptive Current-Limiting Ability

A Dual-Stage Solid-State Fault-Current Limiter for Flexible DC Distribution Networks

Development of Rapid Identification Device About DC Short Circuit Fault Current Based on DSP

Research on DC Electric Shock Protection Method Based on Sliding Curvature Accumulation Quantity

Research on methods of non-communication protection for shipboard loop power distribution systems

A New Method to Detect the Short Circuit Current in DC Supply System Based on the Flexible Rogowski Coil

A High Speed Single-Ended Fault-Detection Method For Dc Distribution Line-Part Ii: Protection Scheme

A NEW DEVICE DETECTING GROUND FAULT AND SHORT CIRCUIT PROTECTION FOR DC CONTROL CIRCUIT