Abstract:The corrosion of alkaline concrete materials exposed to a sulfuric acid environment is becoming more and more prevalent, and its damage assessment is becoming more and more imperative. This study aims to describe the corroded surfaces of concrete with different strength grades (C30, C50, C80) in sulfuric acid environments in terms of their three-dimensional fractal dimension. Three kinds of concrete with varying strength grades, namely C30, C50, and C80, were immersed in a sulfuric acid solution with pH ≈ 0.85 for four distinct corrosion durations, specifically 0, 28, 56, and 165 days, in accelerated corrosion tests. The 3D laser scanning technique was utilized to capture the 3D coordinates of the surface points of the concrete cylinder before and after corrosion. The fractal dimension of concrete's uneven surface before and after corrosion was computed via the cube covering method, and the mass loss of the concrete specimen was also obtained. The outcomes demonstrate that the three-dimensional fractal dimension provides a new method for characterizing the degree of corrosion deterioration of concrete samples affected by sulfuric acid via laser scanning technology. From the perspective of the appearance, mass loss, and fractal dimension of a rough surface in the sulfuric acid environment at a pH level of approximately 0.85, the degree of the corrosion deterioration of concrete is ranked from high to low as C80 > C50 > C30. These fractal dimensions of the concrete's corroded surfaces with various strength grades increase rapidly in the initial period. However, as the corrosion time progresses, the growth rate of the corroded surface fractal dimension gradually decelerates and tends towards stability, which accords with the law of exponential function. The widespread belief is that the higher the strength grade of concrete, the better its durability; however, this pattern varies in sulfuric acid corrosive environments. Therefore, based on this research, it is recommended that in extremely acidic environments (i.e., very low pH), more attention should be paid to high-strength grades of concrete.

Influence of polymer addition on biogenic sulfuric acid attack of concrete

Study on the Behavior and Durability of Reinforced Concrete in Boric Acid Environment

Biogenic corrosion of cementitious composite in wastewater sewerage system–A review

Proportioning Study for Low-carbon Sulfate-resistant Concrete by Microbial Corrosion Testing

Resistance of Chloride and Sulfate of Geopolymer based on fly ash and silica fume as alternative raw materials.

Evaluation of the Protection Ability of a Magnesium Hydroxide Coating against the Bio-Corrosion of Concrete Sewer Pipes, by Using Short and Long Duration Accelerated Acid Spraying Tests

Effect of polymer on the microstructure and resistance to corrosion of oil well cement stones

Effect of novel gram-positive bacteria and fungi on the durability, corrosion resistance performance, and self-healing ability of concrete over various curing conditions

Advances in the Mitigation of Microbiologically Influenced Concrete Corrosion: A Snapshot

Research on the Sulfate-resistant Chemical Attack Mechanism of Concrete with Mineral Admixture

Geopolymers functionalised by antibacterial zeolite against biocorrosion

Microbiologically Induced Concrete Corrosion: A Concise Review of Assessment Methods, Effects, and Corrosion-Resistant Coating Materials

Bio-corrosion in concrete sewer systems: Mechanisms and mitigation strategies

Effect of Chemical Composition of Fine Aggregate on the Frictional Behavior of Concrete–Soil Interface under Sulfuric Acid Environment

Microbial acidification by N, S, Fe and Mn oxidation as a key mechanism for deterioration of subsea tunnel sprayed concrete

Deterioration Mechanisms of Ultra-High-Performance Concrete Under Various Sulfuric Acid and Sulfate Attack Conditions

Experimental Investigation on the Influence of Strength Grade on the Surface Fractal Dimension of Concrete under Sulfuric Acid Attack

Sulfate attack on concrete with mineral admixtures

Understanding the early-stage spatially distributed behaviors of microbially induced concrete corrosion in the sewer system

Effect of Matrix Modification on Durability of Cementitious Composites in an Acid Rain Environment

Biogenic sulfuric acid corrosion resistance of new artificial reef concrete