Abstract:The structural and mechanical properties, e.g., lattice constants, elastic constants, elastic moduli, Poisson’s ratios, and Vickers hardness, of L12-(Ni x1,Cr x2,Co x3)3(Al y1,Ti y2) precipitates are predicted by high-throughput first-principles calculations combined with exact muffin-tin orbitals and coherent potential approximation methods. It turned out that the elastic constants C 11 and C 44 , shear modulus, Young’s modulus, Vickers hardness, and yield strength raise with increasing Ni, Cr, Co, or Al content as a whole, the elastic constant C 12 , Poisson’s ratios, and Pugh’s ratio decrease gradually, reflecting that the content change of Ni, Cr, Co elements on the left has basically similar effects on the physical properties of L12 precipitates, while the influences of Al and Ti on the right are opposite. Moreover, increasing Ni and Al, Cr and Al, or Co and Al contents at the same time is more conducive to improve the deformation resistance of alloys, but rapidly decrease the plastic properties. Meanwhile, the crystal structures of L12 precipitates may be mechanically unstable due to negative C 11 − C 12 values when Ni, Cr, or Co concentration is less than 30 at%, and the ductile-brittle transition will occur for the L12 particles with high Cr and Al contents or Co and Al contents due to B / G < 1.75 . By comparison, Co3Al and Cr3Al precipitates exhibit excellent deformation resistance, (Cr,Co)3Ti and (Ni,Co)3Ti particles demonstrate outstanding plastic properties in the [001] and [111] directions, respectively. This work provides valuable insights for the intrinsic properties of L12-(Ni x1,Cr x2,Co x3)3(Al y1,Ti y2) precipitates.

Structural，elastic and Electronic Properties of L12 Aluminum Phases from First Principles Calculation

Ab Initio Calculation of Structure and Thermodynamic Properties of Zintl Aluminide SrAl2

The first-principles calculations for the elastic properties of Zr2Al under compression

The Structural, Elastic And Thermodynamic Properties Of Intermetallic Phases In Mg-Sn-Si-Ca(Sr) Alloys: A First-Principles Study

The Thermal Properties of L12 Phases in Aluminum Enhanced by Alloying Elements

Novel High-Pressure Phases of Alp from First Principles

Effect of Zr, Hf, and Sn Additives on Elastic Properties of Α2-Ti3al Phase by First-Principles Calculations

Designing elastic modulus of Al3X precipitates in Al alloys by identifying effective atomic bonds and stabilizing coherent structures

Nucleation of L12-Al3M (M = Sc, Er, Y, Zr) Nanophases in Aluminum Alloys: A First-Principles ThermodynamicsStudy

Mechanical And Thermodynamic Properties Of Mg17la2, La5si4 And La5sn3 Phases In Mg-Sn-Mn(Si)-La Alloy From First-Principles Calculations

Mechanical properties of defective L12-Al3X (X = Sc, Lu) phase: A first-principles study

FIRST-PRINCIPLES INVESTIGATION OF THE THERMODYNAMICS PROPERTIES OF Al3Sc AND Al3Zr INTERMETALLICS

First-Principles Investigations on Structural Stability, Elastic Properties and Electronic Structure of Mg32(Al,Zn)49 Phase and MgZn2 Phase

The Structural, Elastic, and Electronic Properties of Zr X Nb 1− X C Alloys from First Principle Calculations

Theoretical Prediction of Structural, Mechanical, and Thermophysical Properties of the Precipitates in 2xxx Series Aluminum Alloy

First-principles Investigation of the Structural, Mechanical and Thermodynamic Properties of Al2Cu Phase under Various Pressure and Temperature Conditions

Elastic Properties and Electronic Structure of L1<sub>2</sub> (Al,si)<sub>3</sub>sc

Phase Diagrams and Elastic Properties of the Fe-Cr-Al Alloys: A First-Principles Based Study

High-throughput prediction of intrinsic properties of L12-(Ni1,Cr2,Co3)3(Al1,Ti2) precipitates

First-principles studies on phase stability, anisotropic elastic and electronic properties of Al-La binary system intermetallic compounds

Prediction of heat-resistant Al–Fe–Cu–Zr alloy from first-principles calculations: Stoichiometries, electronic structure, and physical properties