Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

Multi-scale mathematic modeling of non-isothermal polymeric flow of fiber suspensions

A Multi-Scale Model with Generic Structure of Polymeric Melt with Fiber Suspensions

Microstructures of fiber suspensions in complex geometry

Numerical Simulation of the Non-isothermal Viscoelastic Flow Past a Confined Cylinder

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Numerical Study on Fiber Suspensions in Non-Isothermal Viscoelastic Media

Modeling and Simulation of Fiber Reinforced Polymer Mold Filling Process by Level Set Method

Numerical simulation on velocities of two interacting fibers in fiber suspension

Numerical Investigation of Three-Dimensional Fiber Suspension Flow by Using Finite Volume Method

Meso-Macro Scale Behavior Analysis of Polymeric Systems under their Melting States

Numerical Simulation of Flow-Induced Stresses in Mold Filling Process Using a Three-Dimensional Two-Phase Flow Model

Constitutive Equations of Non-Isothermal Polymer Melt

Microstructures of Polymer Solutions of Flow Past a Confined Cylinder

Numerical Simulation of Interactions Between Rigid Rod-Like Polymers and Coherent Structures in a Mixing Layer

Multiscale Rheology Model for Entangled Nylon 6 Melts

Numerical Simulation Of Fiber Spinning Process With Structure Evolution Of Polymer Chains

Investigation of the Rheological Behaviors of Polymeric Materials in the Film Casting Process Through Multiscale Modeling and Simulation Method

COUPLING SIMULATION MODEL OF MELT FLOW AND FIBER ORIENTATION FOR FIBER REINFORCED PLASTICS IN INJECTION MOLDING

Multiscale modeling and simulation for polymer melt flows between parallel plates

A Multiscale CFD-PBM Coupled Model for the Kinetics and Liquid–liquid Dispersion Behavior in a Suspension Polymerization Stirred Tank

Multiscale simulation of polymer melt spinning by using the dumbbell model