Abstract:The wave glider is a surface vehicle with an attached sub-surface wing system which propels the surface component forward, negating the need for a motor. Wave glider could be used for intelligence, surveillance, passive monitoring of marine life, monitoring exclusive economic zones for fishing and other economic resources that are important and useful to coastal countries. Monitoring of coastal waters normally requires large amounts of expensive surveillance. They can be used to find and research resources and fisheries at a fraction of the cost of other methods. Since the wave glider can either be programmed for a journey or to keep station, it is looked at as an alternative for expensive moored buoys. In this paper we present a method focused on the mesh generation to predict calm water resistance for the floating part of the wave glider (the hull). In this study a wigley hull form (4m) used as the floating hull has been investigated in order to predict the fluid flow of the ship using computational fluid dynamics (CFD). Calculations for total resistance are carried out for Froude numbers in the range of 0.10 to 0.40. Commercial CFD software fluent is used to investigate the fluid flow of wigley hull. Three different mesh sizes are used in this study to calculate the mesh effects. The results obtained from CFD calculations for total resistance are compared with the experimental results for accuracy of the solution parameters. The comparison shows a good agreement between experimental and CFD results. The method is evaluated by comparing the numerical predictions for wigley hull form (2m) with wigley hull form (4m) using the same mesh sizes under the same conditions in an attempt to design the floating hull of wave glider . The results obtained from CFD calculations are compared for accuracy of the solution parameters and the method is useful and acceptable.

Numerical Analysis of Resistance Characteristics for High-speed Amphibious Vehicle Sailing on Water

Boat Trial Validation and Resistance Prediction of a 36-Foot Hydrofoil Catamarans Using CFD

Experimental and CFD investigation on resistance reduction of hydrofoils for amphibious vehicles

Study on the Resistance of a Large Pure Car Truck Carrier with Bulbous Bow and Transom Stern

Numerical and Experimental Study on A 2-D Floating Body under Extreme Wave Conditions

Numerical Simulation of Water Entry of Two-Dimensional Structures with Complex Geometry Using a CIP-based Model

Research on Hydrodynamics of Trans-Media Vehicles Considering Underwater Time-Varying Attitudes

A Numerical Study on the Resistance Prediction of a Medium Speed Craft

Resistance prediction method research of high speed trimaran

Numerical Simulation of the Horizontal Water-Entry Process of High-Speed Vehicles

Numerical Analysis for Resistance Calculations of NPL As a Floating Hull for Wave Glider

A Computational Fluid Dynamics Method for Resistance Prediction of the Floating Hull of Wave Glider

Research on Wave-Added Resistance and Longitudinal Stability Characteristics of Amphibious Aircraft in Rule Wave

Comparative Investigation of an Automated Oceanic Wave Surface Glider Robot Influence on Resistance Prediction Using CFD Method

Drag reduction configuration analysis of the grooves on amphibious vehicles walking mechanism

Numerical investigation on the inhibition of porpoising instability for high-speed amphibious vehicles

Numerical Investigation on the Cavity Behavior and Hydrodynamic Performance of a Planing Air Cavity Ship

Numerical Simulation of Viscous Flow Around High Speed Monohull and Trimaran Ships

Study on the Impact of Tail Wing Profiles on the Resistance Characteristics of Amphibious Vehicles

Resistance Calculation and Analysis of Underwater Vehicle-Manipulator Systems

Hydrodynamic Investigations of a Cross-Domain Vehicle with the Capability of High-Speed Cruising on Water Surface