Abstract:The influence of the mineral composition of water on the results of silicon determination by high-resolution atomic absorption spectrometry with a continuous spectrum source (HR-CS-ETAAS) and electrothermal atomization technique using a contrAA 700 spectrometer has been studied. The study was conducted using samples of natural water from different regions of the Russian Federation and model solutions. A low degree of silicon atomization was recorded when analyzing samples with a complex matrix against the background of a strong absorption signal of matrix components. The reason for the non-selective absorption of the sample matrix by chemical compounds has been demonstrated using a water sample with the most complex composition and a total hardness of about 2000 °dH. The effect of soluble salts of Ca (II) and Mg (II) in the presence of macrocomponents — alkali metal ions K (I) and Na(I) — on the determination of silicon in water has been proved. It is shown that at the values of the total stiffness less than 15 °dH there is no dependence of the analytical signal on the content of matrix components. An assumption is made about the strong influence of calcium compounds on the determination of the analyte due to the formation of a carbide coating on the surface of a graphite furnace, the appearance of a «memory effect» and an increase in the background signal during subsequent atomization cycles. The best results of the silicon determination were obtained with tungsten, iron, magnesium, and palladium present as chemical modifiers. A method of diluting the sample solution was used to reduce the level of background absorption during electrothermal atomization of mineral water. Conditions for eliminating the influence of matrix components for real samples of mineral water and calibration solutions are proposed. A method for determination of the dissolved forms of silicon in water samples with a complex matrix has been developed. The correctness of the results of silicon determination in the samples of natural underground water in the case of a strong matrix effect was confirmed by an independent method of analysis. The results of the study reveal the entirely new prospects of using the method of high-resolution electrothermal atomic absorption spectrometry with a continuous spectrum source for the determination of silicon in natural water.

THE DETERMINATION OF Se ENVIRONMENTAL BACKGROUND VALUE IN NATURAL RIVER WATER USING MIXED MATRIX MODIFIER-STPF

Flow Injection On-Line Sorption Preconcentration Coupled with Hydride Generation Atomic Fluorescence Spectrometry Using A Polytetrafluoroethylene Fiber-Packed Microcolumn for Determination of Se(Iv) in Natural Water

Simultaneous Enrichment of Inorganic and Organic Species of Lead and Mercury in Pg L−1 Levels by Solid Phase Extraction Online Combined with High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry

Stability of selenium and its speciation analysis in water using automatic system separation and HR-ICP-MS measurement

Quantification of ultra-trace organolead species in environmental water by inductively coupled plasma mass spectrometry with online solid-phase extraction and high performance liquid chromatographic separation

Simultaneous speciation of inorganic arsenic, selenium and tellurium in environmental water samples by dispersive liquid liquid microextraction combined with electrothermal vaporization inductively coupled plasma mass spectrometry

A Chelating Resin of EDTA-Type Modified Cross-Linking Polystyrene to Preconcentrate Trace Metals for Seawater Detection

Preconcentration of Trace Elements from Natural Water with Palladium Precipitation

Novel Approach for the Accurate Determination of Se Isotope Ratio by Multicollector ICP-MS

Evaluation of internal standardization for the determination of semivolatile analytes in difficult matrices by simultaneous multielement atomic absorption spectrometry

Study of the effect of matrix components of natural mineral water on the determination of dissolved forms of silicon by high-resolution electrothermal atomic absorption spectrometry with a continuous spectrum source

Simultaneous Determination of Mercury, Lead and Cadmium Ions in Water Using Near-Infrared Spectroscopy with Preconcentration by Thiol-Functionalized Magnesium Phyllosilicate Clay.

Species selective concentration and determination of nano-selenium and inorganic selenium species in environmental waters by micropore membrane filtration and ICP-MS

Hyphenation Of C-18 Gel Silica Column And Flow Injection With Inductively Coupled Plasma-Mass Spectrometry And Its Application On The Seawater Analysis

THE DETERMINATION OF TRACE AMOUNTS OF HEAVY-METALS IN WATERS BY A FLOW-INJECTION SYSTEM INCLUDING ION-EXCHANGE PRECONCENTRATION AND FLAME ATOMIC-ABSORPTION SPECTROMETRIC DETECTION

Electrodeposition as a Preconcentration and Sample Preparation Technique for Trace Selenium and Tellurium Determination by X-Ray Fluorescence Spectrometry

Determination of Trace Iodide in Drinking Water in Shanghai by Two Columns and Gas Chromatography with Electron Capture Detection

Direct determination of high-concentration As(III) by UV high-reference differential absorption spectroscopy for cleaner As(III) removal promotion via sulfurization

ION CHROMATOGRAM METHOD FOR ANALYZING ANIONS AND CATIONS IN PORE WATER FROM MARINE SEDIMENTS

On-site Separation of Arsenic Species in Natural Waters by Tandem Ion-Exchange Columns and Detection by ICP-MS

Simultaneous on-line preconcentration and determination of trace metals in environmental samples using a modified nanometer-sized alumina packed micro-column by flow injection combined with ICP-OES