Abstract:Fine-grained Al-xMg (x = 4.5, 6.5 and 9.2, in wt%) alloy sheets with high damping capacity and excellent ductility are prepared by high strain rate rolling (HSRR). Both the damping capacity and the mechanical properties of the alloys are improved compared with the as-homogenized states and increase with the higher Mg content. The three AlMg alloys exhibit similar strain-amplitude-independent damping capacities and the Al-9.2 Mg alloy is a little bit higher. While the strain-amplitude-dependent damping capacity increases with increasing the Mg content in a large strain amplitude range. The as-HSRRed Al-4.5 Mg, Al-6.5 Mg and Al-9.2 Mg alloys exhibit the damping values (Q−1) of 0.0140 ± 0.0005, 0.0167 ± 0.0006 and 0.0178 ± 0.0008 at the strain amplitude of 1 × 10−3. Furthermore, a combination of high ductility (42.8 ± 1.5%), moderate strength (435 ± 2 MPa) are also achieved in the Al-9.2 Mg alloy. The improved damping capacity of the as-HSRRed Al-9.2 Mg alloy are mainly attribute to the low stacking fault energy and the movement of the extended dislocation, the latter of which interaction with Suzuki atmosphere and thus increases energy consumption which plays a dominant role in the damping mechanism of the as-HSRRed alloys. The results of the present study provide new ideas for the development of high damping alloys with high mechanical property.

High Damping Capacities of Mg-Cu Based Alloys

Low Frequency Damping Behaviors of Magnesium Alloys

A Study of Damping Capacities in Pure Mg and Mg–Ni Alloys

Low Frequency Damping Capacities and Mechanical Properties of Mg–Si Alloys

A Study on the Damping Capacities of Mg–Zn–Y-Based Alloys with Lamellar Long Period Stacking Ordered Phases by Preparation Process

Low frequency damping capacities of commercial pure magnesium

A Transmission Electron Microscopy Investigation of Defects in an Mg-Cu-Mn-Zn-Y Damping Alloy

Effect of Small Tensile Deformation on Damping Capacities of Mg-1%Al Alloy

The ultrahigh damping capacity of Mg-Sn-Y alloy

Microstructure and damping properties of Mg–Si binary hypoeutectic alloys

Effects of Cu and Mn on Mechanical Properties and Damping Capacity of Mg-Cu-Mn Alloy

Achieving high damping and excellent ductility of Al Mg alloy sheet by the coupling effect of Mg content and fine grain structure

Effect of alloying elements and heat treatment on damping capacity of Mg-Al alloys.

Temperature Damping Capacity and Microstructure Evolution of Mg–Al–Zn–Sn Alloy

Effect of Deformation on the Damping Capacity of Magnesium Alloys

High damping capacity of a Ni-Cu-Mn-Ga alloy in wide ambient-temperature range

The characteristic of damping peak in Mg–9Al–Si Alloys

Solid solution strengthening and damping capacity of Mg−Ga binary alloys

Effect of Heat Treatment on the Stability of Damping Capacity in Hypoeutectic Mg–Si Alloy

Probing the Varying Ranges of Damping Capacity of Magnesium Alloys Containing Long-Period Stacking Ordered Phases

Effects of Extrusion on the Mechanical Properties and Damping Capacity of Mg-1.8cu-0.5mn Alloy