Abstract:Magnesium alloys have received much attention for their lightweight and other excellent properties, such as low density, high specific strength, and good castability, for use in several industrial and commercial applications. However, both magnesium and its alloys show limited room-temperature formability owing to the limited number of slip systems associated with their hexagonal close-packed crystal structure. It is well known that crystallographic texture plays an important role in both plastic deformation and macroscopic anisotropy of magnesium alloys. Many authors have concentrated on improving the room- temperature formability of Mg alloys. However, despite having a lot of excellent properties in magnesium alloy, the study for various properties of magnesium alloy have not been clarified enough yet.Mg alloys are known to have a good damping capacity compared to other known metals and their alloys. Also, the damping properties of metals are generally recognized to be dependent on microstructural factors such as grain size and texture. However, there are very few studies on the relationship between the damping capacity and texture of Magnesium alloys. Therefore, in this study, specimens of the AZ31 magnesium alloy, were processed by hot working, and their texture and damping property investigated. A 60 mm × 60 mm × 40 mm rectangular plate was cut out by machining an ingot of AZ31 magnesium alloy (Mg-3Al-1Zn in mass%), and rolling was carried out at 673 K to a rolling reduction of 30%. Then, heat treatment was carried out at temperatures in the range of 573-723 K for durations in the range of 30-180 min. The samples were immediately quenched in oil after heat treatment to prevent any change in the microstructure. Texture was evaluated on the compression planes by the Schulz reflection method using nickel-filtered Cu Kα radiation. Electron backscatter diffraction measurements were conducted to observe the spatial distribution of various orientations. Specimens for damping capacity measurements were machined from the rolled specimen, to have a length of 120 mm, width of 20 mm, and thickness of 1 mm. The damping capacity was measured with a flexural internal friction measurement machine at room temperature. It was found that the damping capacity increases with both increasing heat-treatment temperature and time, due to grain growth and the increased pole densities of textures.

Low frequency damping capacities of commercial pure magnesium

Low Frequency Damping Behaviors of Magnesium Alloys

Damping Capacity of Several High Strength Magnesium Alloys

A Study of Damping Capacities in Pure Mg and Mg–Ni Alloys

A Study on the Damping Capacities of Mg–Zn–Y-Based Alloys with Lamellar Long Period Stacking Ordered Phases by Preparation Process

Low-Frequency Damping Behavior of Pure Mg Processed by Equal Channel Angular Pressing

Effect of alloying elements and heat treatment on damping capacity of Mg-Al alloys.

Low Frequency Damping Capacities and Mechanical Properties of Mg–Si Alloys

Research Progress on the Damping Mechanism of Magnesium Alloys

Damping behavior and energy absorption capability of porous magnesium

Effect of Small Tensile Deformation on Damping Capacities of Mg-1%Al Alloy

The characteristic of damping peak in Mg–9Al–Si Alloys

Effect of texture on damping behaviour in ZK60 magnesium alloy

Damping capacity of pure magnesium matrix composites

The ultrahigh damping capacity of Mg-Sn-Y alloy

Damping Characterization of Magnesium Matrix Composites Prepared by In-Situ Synthesis Technique

Probing the Varying Ranges of Damping Capacity of Magnesium Alloys Containing Long-Period Stacking Ordered Phases

Effect of hot working on the damping capacity and mechanical properties of AZ31 magnesium alloy

Mechanical Properties and Damping Behavior of Magnesium Alloys Processed by Equal Channel Angular Pressing

Effect of Deformation on the Damping Capacity of Magnesium Alloys

Experimental study on damping performance of magnesium alloy AZ31